Thank you. Glad it helped out. Hope you get to join the Honda Pioneer club.

Fantastic. Sure adds a lot of storage!

Thank you very much.

Thank you! Appreciate the comment.

Thanks! Appreciate it!

Thank you!

I have not had any issue. I have seen others add weather stripping around the cut opening, but I haven’t had a reason to yet. Thanks for watching!

I haven’t had any issues at all and have quite a bit of weight in the doors.

Camso 4s1. I have been incredibly happy with them. No issues and they have lots of miles on them.

I got them on Amazon. I was going to attach the link but they are currently showing unavailable. Go to Amazon and search “vehicle hood pins”. There are multiple manufacturers. Hope that helps. Good luck

I am not sure what black tabs you are referring to. On mine, the panels were held in with screws. You unscrew the panel, then screw post into the hole. Drill out the panel and insert the snap button. No black tab. Is yours a newer year? Wondering if they changed something. Sorry I am not more help.

My 2022 Pioneer 1000-5 only had the plastic push tabs that hold the panels on. I used M6 rivet nuts and the rivet nut tool to give the ball/ bolt something to thread into. Once I got the ball/bolt set to the dept I need for the push button to latch on to it without a lot of play, I locked the ball/bolt into place from the inside with the nut that was provided with the ball/bolt. I used a pair of vice grip pliers to hold the end of the ball(applied enough pressure to grab it without tearing up the ball)while I tighten the nut up against the backside of the rivet nut. I also used loc-tite on the threads. Hope this makes since and works for you.

Could you attach something(maybe a piece of sheet metal) on the inside of the with rivets or glue, then drill your hole and attach nuts? Or I think they make other fasteners designe for those holes-similar to the hood fasteners? Trying to picture what you have going. Too bad they went to the plastic push rivets.

@@fishandsheds1771 so the studs I have are just like yours. I got two nuts and two washers. One set inside and one outside to prevent it going in and out. But it makes the pannel hang off far. And look silly. I was thinking a just getting the threaded things you have. How do they attach?

There is a threaded piece, nut, embedded in the plastic.

Same issue on my 2022 Pioneer. Just a hole and nothing threaded for the screw. Any solutions?

Did my 2023 yesterday. Get some 6mm rivet nuts and a tool and add your own inserts. They fit perfectly and the stud threaded in and used one if the nuts on the backside to lock it in place.

No. None at all and they have been caked in snow and covered in mud to many times to count. So far, no issues.

@@fishandsheds1771 I love the fit and finish of it. Really adds to the usability of the machine. Would I be correct in assuming that the posts are the 2” version vs the 4” version? I’m in Canada so I have a different eBay portal. The link you gave takes me to the US eBay site, but doesn’t reference the length of post. Can’t wait to tackle this project!

@@landcruiserchewy I am amazed at what I can fit in there. It is a bit of a puzzle to get stuff in and out but it works. Thanks and yes, 2 inch.

@@fishandsheds1771 Thanks for your help Greg. Big fan of the channel from what I’ve seen so far. Just bought a 2016 1000-5 Deluxe for a steal of a deal I could not refuse. What a beast!