Honda Rebel (CMX250) Clutch replacement

No video

Honda Rebel (CMX250) Clutch replacement

Рет қаралды 8,334

Күн бұрын

Did you know that you can support us by shopping and it doesn't cost a dime extra? Access Amazon by using our link then simply shop as you would normally: amzn.to/3DB2Wve
If you want to support this channel directly. Donations of any amount can be made quickly and securely here: www.paypal.com...
What about Harvest Hosts?
Become and member and start your own adventure! Always do your host like you would do your favorite server or bartender, take care of them! Check out the program at the following link.
harvesthosts.re...
Check us out at www.homebuilth...

Пікірлер: 11

@alexanderc9058 Жыл бұрын

Great video. If I'm not mistaken, what you were referring to as the "clutch basket" is actually a "clutch pack assembly", and the "basket" is the eight fingered piece with the gear that houses the clutch assembly. I made it here looking on how to remove that basket

@homebuilthappiness2919 Жыл бұрын

You are correct. I refer to the entire assembly as the basket but yes, they are separate components. Thanks for mentioning that.

@adamdelarozza1985 Жыл бұрын

When removing the eng side cover, I use a small rubber/nylon mallet and tap around the perimeter, i don't trust myself w/a prybar 😉 Might as well clean the oil spinner screen as it is right there waiting for a clean screen!

@billykid6434 2 ай бұрын

Thanks alot

@jakehubbard8518 Жыл бұрын

It would’ve been nice if you would have faced the camera back towards the motor so we could see the reassembly at the end instead looking at your face

@homebuilthappiness2919 Жыл бұрын

Sorry it couldn't have been everything you wished for. Thanks for watching.

@CookedAnimalEater 2 жыл бұрын

Let's just take a guess?

@petermarcille5634 Жыл бұрын

What indicates which side of the washer and the plates in the "machined side" and the non-machined side? Thanks!

@danieljones2336 Жыл бұрын

Which way round does the friction plate go?

@robertenglish9838 2 жыл бұрын

I don't recommend he wonder-bar technique. There IS a place on the front of the cover that lets you tap the cover off gently with the HANDLE of a small hammer--or perhaps with a small lenghth of 1x1. If you use that method, you will be guaranteed not to break any fins off the cylinder. The spring washer is called a "Bellville" washer. en.wikipedia.org/wiki/Belleville_washer

@homebuilthappiness2919 2 жыл бұрын

Thank you Robert for the information! I'll keep it in mind and hope it helps others that see this. Can you describe roughly where that location is? I have a 82 CM250 with the same engine that I'll end up doing a clutch on and it would be good to know otherwise I can google it I'm sure. The Belleville washer is also known as a judder spring in some circles, and I think the clymer manual may actually refer to it as that also. Would actually make more sense to call it an "anti judder spring" but its good to know the actual name for it. Sort of how folks call a steering coupler a "rag joint".