Honda SH150i Coolant change pt.2

Рет қаралды 48,205

DaBinChe

10 жыл бұрын

Пікірлер: 33

@erlisiljazi262 5 жыл бұрын

Thank you for the video! Very instructive! Didn't know Honda SH150 is used in the USA!

@Zenpalmelao 10 жыл бұрын

Good vids, man! Thanks

@bernardbrown4880 9 жыл бұрын

Very helpful video thanks

@rons.2561 10 жыл бұрын

also, it is easier if you put the overflow cap/tube on the overflow tank before you reinstall the tank back into the scooter.

@rons.2561 10 жыл бұрын

Hi DaBinChe. I have enjoyed looking at all of your sh150i vids. Good Stuff. I have found it easier to get to the coolant bleeder bolt if you remove the seat/seat pan (4 bolts front and 2 screws in back). I would be great if someone would post front/rear wheel removal too. Thanks!

@DaBinChe 9 жыл бұрын

Ron S. I forgot to make a video when I changed the rear tire, next time

@farmoboy83 8 жыл бұрын

what type of coolant are you using? I suppose i can use the same on the sh300i?! Thank you for your vídeos, i'm gonna try tomorrow to do the same.

@DaBinChe 8 жыл бұрын

+farmoboy83 I use coolant that is safe for aluminum, should be green in color

@erlisiljazi262 5 жыл бұрын

What is the timespan that we should change the coolant?

@04poppop 7 жыл бұрын

Hi, I have changed coolant today as I dont think it has been done from new, I reckon previous owner only added. I got problem, I couldnt lose that bleeding screw, so I just lose bottom one let the old coolant drained and poured new coolant in.

@DaBinChe 7 жыл бұрын

that will be fine, it just means that not all the coolant is drained out

@04poppop 7 жыл бұрын

Thanks for respond, by the way, where do you live, is it USA?

@DaBinChe 7 жыл бұрын

Kalifornia

@04poppop 7 жыл бұрын

Thats nice place, lucky you. I used to work in summer camp in Santa Rosa as student (student exchange program), camp name is Clover leaf ranch. What city is your?

@Baton677 8 жыл бұрын

HeyI got a sh 125 2003, is it the same operation ? My bike overheat, the needle almost goes on the red line, I have to stop the engine and turn on the key to activate the fan and cool it. I guess the needle must be in the middle (between Cold and Hot), do you think the problem comes from the cooling fluid ? Thanks you for your help !

@domasbagdonavicius7598 5 жыл бұрын

If you have not bled the coolant system of air it will cause overheating issues,as the coolant pump cannot pump air through the pump.let the bike cool down then carefully remove the radiator cap and start bike and run engine and watch for air bubble's in radiator filler neck.Give it a good rev to self bleed and do not let temperature of engine get to hot.Be careful!!!

@zbyynniek 6 жыл бұрын

Hello. I have honde dylan 125. What liquid can I pour? Is there a 125 liter or pressure tank in 125? ? and do you have to vent?

@DaBinChe 6 жыл бұрын

Not sure if the dylan 125 is liquid cool or air cool..... if liquid then you use anti freeze coolant/radiator fluid, 50/50 mix with distilled water

@1thomasgoodman 2 жыл бұрын

coolant is dripping from the base of the engine around the sump plug. Where would it be coming from?

@DaBinChe 2 жыл бұрын

check the weep hole should be down there somewhere

@04poppop 4 жыл бұрын

Do you know how much is put inside like 1 - 2 litres?

@DaBinChe 4 жыл бұрын

less then 1 liter

@jamesjamesson3911 3 жыл бұрын

poukissa nou pa palé de fucking boulos ou wan bandi machann micro yo merité metew nan prizon...

@alielsheikh8990 5 жыл бұрын

When should we Change the coolant

@DaBinChe 5 жыл бұрын

every 3 years

@DaBinChe 5 жыл бұрын

Or 5 years if you are using long life coolant

@alielsheikh8990 5 жыл бұрын

Even if I go on a high speed all the time

@DaBinChe 5 жыл бұрын

@@alielsheikh8990 yes

@alielsheikh8990 5 жыл бұрын

So the coolant stays in the scooter from when I bought it till 3 years

@lobo7792 7 жыл бұрын

I thought it was terrible. The jerky herky camera was pathetic. Get a buddy to film.

@DaBinChe 7 жыл бұрын

that is how it is with one hand on the camera and one doing work...not sure how POV porn videos do it, must be expensive equipment. My camera on this video was only $100 from 10years ago