Hood Installation - Poor Man’s Food Truck
Рет қаралды 26,017
Күн бұрынConcession Hood:
m.vevor.com/exhaust-hood-c_10...
Ventilation Direct Fan:
store.ventilationdirect.com/v...
Roof Duct:
www.homedepot.com/p/Active-Ve...
Fan Control:
www.amazon.com/Fantech-WC-15-...
Support Cargo Bar:
www.harborfreight.com/2-in-1-...
Impact Drill Bit Set:
www.harborfreight.com/impact-...
Step-Bit:
www.harborfreight.com/2-piece...
@juanbeltran7696 Ай бұрын
I like your honesty we are in same boat we start to build our second food truck But this time is a 14x8 trailer we just placed the order for the hood system we are doing it from scratch to LOVE YOUR VIDEOS
@raylewis8751 Жыл бұрын
Using the cargo dividers was a genius move. It doesn’t hurt the pocket too bad. I did that yesterday and installed my hood. Thanks for the video.
@poormansfoodtruck Жыл бұрын
They are lifesavers!! Glad that it worked out for you too! Thank you so much for your support 🙏🏻
@earlb-oy2cw 11 ай бұрын
@@poormansfoodtruck can you possibly tell me the measurements on the hood in certain spots if I post link to the pics. It will not let me upload pics thanks
@francescosorrentino1559 5 ай бұрын
@@poormansfoodtruck great video btw. Question could I put the hood at the front of the trailer or is not enough studs there?
@francescosorrentino1559 5 ай бұрын
@@poormansfoodtruck Why dint you use the fan from vevor instead since the hood is??? Wasn’t good? Trying to get the hood from there since they seams to be the cheapest one and I was wondering about their fans
@estelaituarte Жыл бұрын
Thank you for these videos, I am having my truck built and we are using the hood and the fan you suggested.
@poormansfoodtruck Жыл бұрын
That’s awesome! Thank you so much for the support! I think you’ll be happy with the products!
@kniik-knaak 2 жыл бұрын
Good job my friend
@poormansfoodtruck 2 жыл бұрын
Thank you so much! 🙏🏻
@DavidGalan777 Жыл бұрын
Superb video !
@poormansfoodtruck Жыл бұрын
Thank you sir! 🙏🏻
@willied75 2 жыл бұрын
Great job
@poormansfoodtruck 2 жыл бұрын
Thank you sir! 🙏🏻
@angelott4019 Жыл бұрын
I am here in fl to Daytona are glad I ran by your KZfaq I am slowly doing the same as you so far the hood system is my problem
@poormansfoodtruck Жыл бұрын
That’s awesome thank you so much for the support! If there’s anything I can do to help just reach out!
@julianabrag6641 Жыл бұрын
Great video..
@poormansfoodtruck Жыл бұрын
Thank you sir! I appreciate your support 🙏🏻
@mustangdbest220 Жыл бұрын
Just to let you know, the exhaust fan is only 500 CFM on the maximum highest speed says it on the website
@nicholasalexander8069 8 ай бұрын
I'm about to install a hood onto my food truck and I'm just a little bit nervous about putting the wrong Hood in
@JudyHandley53 10 ай бұрын
I noticed that your roof is slightly curved and therefore your hood isn't flat against the wall. Is that OK?
@user-ub4tl5pj4b 4 ай бұрын
Duct should be welded not screwed together.. hood should be mounted to back of wall tightly sealed to prevent grease from buildup and possibly fire
@fordmods7115 6 ай бұрын
Im looking to buy one, And I noticed that vevor is 201 stainless steel and hood Mart 430 that's why I m asking if feel strong?
@Tuezday1388 Жыл бұрын
I am really not wanting to instal a good in my trailer, I’m not even cooking food I just have food warmers. Might have to fork out the cash and bite this bullet though lol. Think I’m going to rearrange the trailer and cook if I have to.
@poormansfoodtruck Жыл бұрын
Depending on your area the health dept may not require you to have one if you’re not physically cooking inside the trailer. But to my knowledge if you do decide to start cooking instead of just warmers, you’ll for sure need one! Hope that I can help if it comes to that!
@fordmods7115 6 ай бұрын
How is the quality of the hood? Feels study?
@philrose7716 3 ай бұрын
How much does that vent hood weigh?
@user-nt1cb3ml4f 11 ай бұрын
Have you had any experience with the low profile hoods? They are designed for low ceiling areas. Any opinions about those? Seems like they give you more head room while cooking..
@poormansfoodtruck 10 ай бұрын
Personally I’ve not had any experience with them - but I will say that they look great! They’re also probably much easier to install and easier to maintain also. In my area at least, I’ve never seen one in action (yet).
@lonniekeller9416 Жыл бұрын
Did your trailer pass inspection with the hood filters that came with the Vevor hood filters? I was told they wouldn’t in Florida but wanted to be sure. Thank you!
@poormansfoodtruck Жыл бұрын
Haven’t had my fire inspection yet - however I know that a fellow food trucker in the same county who passed the inspection no problems
@lonniekeller9416 Жыл бұрын
Right on! Thank you!!
@AshleyBordersTheWriter Жыл бұрын
Did you pass inspection
@poormansfoodtruck Жыл бұрын
@ashleyborders5092 still awaiting final inspection but initial plans are all approved!
@frankwerner9698 Жыл бұрын
How do you run an exhaust hood and AC unit? I was also wondering if it was possible to put the exhaust closer to the grill?
@poormansfoodtruck Жыл бұрын
For me, I won’t be using an AC unit (too much electrical power is required). I’m sure that you could, however it may be easier to raise your equipment a little higher, than to lower the exhaust hood?
@frankwerner9698 Жыл бұрын
@Poor Man's Food Truck the reason I thought to lower the hood was to catch the heat before it is all over the rig. More efficient? Just speculating a posible design improvement.
@samtadros6996 Жыл бұрын
I can’t find the hood duct you used anywhere. Home Depot is showing a different picture. Any recommendations. Thanks
@poormansfoodtruck Жыл бұрын
I will try to update the link for you! Otherwise search for “food truck roof curb” and they should populate
@samtadros6996 Жыл бұрын
@@poormansfoodtruck thank you
@Amine-sk2vr Жыл бұрын
Did you get greace filters for it? If so from were thank you
@poormansfoodtruck Жыл бұрын
Not yet - but I do plan on getting some extra! Will post an update on the IG page when I do
@christopherrasmussen9864 Жыл бұрын
How did you cut the square hole in the hood vent?
@poormansfoodtruck Жыл бұрын
I used an angle grinder with a 4.5” grinding disc
@thankyouvlog9333 2 жыл бұрын
What size your trailer buds. Thank you
@poormansfoodtruck 2 жыл бұрын
Mine is a 7x16ft my friend!
@jayskitchen616 11 ай бұрын
Do you build food truck from people if they have their owner trailer
@poormansfoodtruck 11 ай бұрын
I have helped with certain parts for others - however my schedule is pretty limited to be honest
@TrueMLC Жыл бұрын
How about ansul?. Did the fire department do that for you or did you by pass it with fire extinguishers. Thanks. And love your videos wish you luck on your venture.
@poormansfoodtruck Жыл бұрын
Hey! I’m having all of my fire suppression equipment professionally installed by a local vendor (I’m not willing to take any risks). Thank you so much for the support! I’d recommend reaching out to some local pros who can quote you on doing the job?
@elperrocovero Жыл бұрын
@@poormansfoodtruck Hi, is it required to get the fire suppression done by a professional in Florida ?
@jers3057 2 жыл бұрын
Do you have to add a fire suppression system in Florida
@poormansfoodtruck 2 жыл бұрын
Yes! Great question! Automatic fire suppression system is required in FL. I will be having mine installed by a third-party as it also needs to be certified. This will be one of the final steps of my build
@etgrider77 2 жыл бұрын
@@poormansfoodtruck How much is the fire suppression with installation and certicification?
@poormansfoodtruck 2 жыл бұрын
I don’t have a final quote yet, but at least in my area it’ll be somewhere in the $3000-$3500 range
@jamesjr3802 Жыл бұрын
Link for the window if you could please and thanks
@jamesjr3802 Жыл бұрын
Never mind I saw you have another video. Thanks
@poormansfoodtruck Жыл бұрын
You got it! Thank you for the support 🙏🏻
@etgrider77 2 жыл бұрын
What did you cut the hole in roof with.
@poormansfoodtruck 2 жыл бұрын
Used a standard angle grinder with a 4 1/2” cutting disc
@poormansfoodtruck 2 жыл бұрын
Check out my concession window installation videos I’ve linked my tools in the description 👍🏻 thank you for the support!
@nicholasalexander8069 8 ай бұрын
did your food truck hood pass your inspections?
@poormansfoodtruck 7 ай бұрын
It passed my fire inspection, still awaiting our final inspection from the DPRB! Will post an update soon!
@JohnnieGraham-wy6cv 11 ай бұрын
A link for the vent you us
@poormansfoodtruck 10 ай бұрын
Should be attached in the video description
@angelajones6254 Жыл бұрын
Hello do you install hood system?
@poormansfoodtruck Жыл бұрын
Hey Angela shoot me a message via the Instagram page or email me: poormansfoodtruck@gmail.com
@josesoto8136 Жыл бұрын
My trailer is only 5 ft wide...is that the cheapest nsf approved
@poormansfoodtruck Жыл бұрын
This was the “best priced” I could find in terms of quality and price. I’m sure there are cheaper out there but I didn’t want to sacrifice quality also. For the record, it works great!
@josesoto8136 Жыл бұрын
Tank you u help a lot
@poormansfoodtruck Жыл бұрын
Anytime!
@angelott4019 Жыл бұрын
Ya this fl weather is terrible
@poormansfoodtruck Жыл бұрын
For real!
@jetlim1477 2 жыл бұрын
Great job
@poormansfoodtruck 2 жыл бұрын
Thank you so much! 🙏🏻
Nikita Zdradovskiy
Рет қаралды 6 МЛН
Boston Hood Cleaning & Restaurant Ventilation
Рет қаралды 184 М.
Real American Muscle
Рет қаралды 3,4 М.