I’m sorry this is terrible instruction and even dangerous. Do not just screw in until it hits the shell holder. You can WAY oversize your case this way to less than SAMI minimum spec. This video (5years ago) costs me a lot of good brass I ruined.
@njgrplr20075 жыл бұрын
Teaching reloaders how to reset a case to SAAMI minimums is dangerous. It puts them on a path to experiencing case head separation. Too often I talk to people that have no idea what headspace is because those teaching reloading view the topic as too advanced. It's not.
@darrellblanchard23622 жыл бұрын
This method doesn't help someone looking for accuracy and could shorten brass life considerably.
@samanthawilliams86288 жыл бұрын
I have a "New Dimension" match grade f/l sizer in .223 with a bushing inside. Where does it show that in the vid?
@justsaying35946 жыл бұрын
Sure wish I would have way he's this video before getting my 308 case stuck.
@theindooroutdoorsman4 жыл бұрын
What happens when our die randomly starts holding the brass and we have to hammer the lever to get the brass out? I've already tried disassembling the die and cleaning it and the cases are lubed properly.
@jamespugh2 сағат бұрын
This kind helped. Not for internal adjustment for the pin length. Got use two small channel locks .
@junmadrid20102 жыл бұрын
You did not consider the cam-over of the ram. This can damage the die, the press or both!! Please correct this !!
@3rwparks33 жыл бұрын
How do you adjust for shoulder bump ????
@guitarplayer14342 жыл бұрын
I sure am glad I bought a match grade die set .. Now i get to search the web for numerous items it did not come with and the videos on how to use the extra items I did not even know I needed
@woodyhayes74028 жыл бұрын
Absolutely the way an instructional video should be done.
@firesnake65564 жыл бұрын
Thank You! Its the grease I couldnt figure out.
@dannie31173 жыл бұрын
Thank you
@JB-kf3yb6 жыл бұрын
I’m really conflicted Hornady!
@JoZf_Gibson
Merci
@claycam673 жыл бұрын
Need to adjust downward another 1/4 turn after die hits the plate. Maybe I got a bad die or my AP is bad, either way I have to make this adjustment to get rounds to properly gauge and chamber.
@Mac-mu9cs3 жыл бұрын
In the instructions it says to have the ram at its highest setting with out caming over. The ram reaches its highest point before the handle is pulled to its lowest point.
@anthonymurphy25402 жыл бұрын
I am reloading 6.5 grendel and I still not getting full lock up on bolt and I tried multiple rifles. Tried 1/4 additional turn, and my hornady case gauge says that it should be good. I get full lock up with factory ammo. I had no other issues with my other reloads. Thinking about using a different die set, any recommendations?
@beanerflowers098 жыл бұрын
I've always read that once you've gotten the die turned down to meet resistance with the ram you lift the ram up and turn the die again approx one half turn.
@khaair6 жыл бұрын
Is the spindle supposed to be of center, because mine is. If not, how do I fix it?