Hot Rod Deluxe Repair part 1
Рет қаралды 767
7 ай бұрынTubes were as old as the amp. All tested low. High voltage capacitors were forming crust on the + node. Channel switching was intermittent. All fixed.
www.rocknrollamps.com
Fender hot rod deluxe channel switching problem
#hotroddeluxerepair
@ShouldHaveBeen 6 ай бұрын
My Hot Rod Deluxe had the resistor issue. I replaced them and gave them about a half inch to an inch of clearance off the board. I recapped it since I was in there. I also, cut a hole in the back and put in a dc brushless fan right over the resistors.
@rocknrollamps 6 ай бұрын
Whatever works for ya. I have done at least a dozen or more of these mods and never had a call back doing it this way.👍🎸
@ShouldHaveBeen 6 ай бұрын
@@rocknrollamps Do the different resistors require a different bias? If it happens again I'll consider doing it your way.
@rocknrollamps 6 ай бұрын
@@ShouldHaveBeen The bias is not affected. They are 330 ohm 5 watt
@ShouldHaveBeen 6 ай бұрын
@@rocknrollamps Thanks. Very helpful. I love my Hot Rod Deluxe and would hate if I had to stop using it. Do you see the same issue with the Blues Junior or Hot Rod Deville?
@rocknrollamps 6 ай бұрын
@@ShouldHaveBeen Hot Rod Deville.
Gray Bench Electronics
Рет қаралды 10 М.
Nikita Zdradovskiy
Рет қаралды 7 МЛН
steveward guitars
Рет қаралды 3,8 М.
Psionic Audio
Рет қаралды 25 М.
Black_АРБУЗНЫЙ
Рет қаралды 3,4 МЛН