A cause of a drive belt shredding on the dryer is because of a design fault. The screws holding the baffles inside the drum, snag the belt and eventually it starts to wear the belt edge, which will cause it to fail over time.
Пікірлер: 14
@kwabenakimathi239415 күн бұрын
It doesn't need to catch on the screws. The belt can be moved slightly to the right. It might be a good idea to loosen the tension by removing the spring and then line the belt up properly on he teeth of the shaft and more to the right hand side of the jockey wheel. Incidentally that jockey wheel should also be replaced with a newer white one which has a nut on the end, as the older black ones are known for coming loose and wobbling.
@dominotr7 Жыл бұрын
Ive just come across this vid, suffered 4 belt failures in 3 years of ownership. Totally agree - poor design! On my next belt replacement - later today, I’m replacing those two screws that impact the belt with mirror dome cap screws to try and resolve this. Fingers crossed.
@mrflashbang5445 Жыл бұрын
First thing I noticed when I stripped ours down was how close the belt had been to the screws. Maybe best when replacing the belt is to shift the alignment on the pulley to the right seeing as the new belts have only 6 ribs.
@philhopkins1375 Жыл бұрын
How do you change the belt? Need to get it on the other side of the fan bar near the pully
@martins5174 Жыл бұрын
Could the screws be changed for dome heads or counter sunk maybe
@davidnicholson25992 жыл бұрын
Could you tape over or cap the screws?
@Flavuk11 ай бұрын
Cover the screws with something smooth it out Hopefully you rectify the design fault that way ?
@MrHotass81 Жыл бұрын
can you show were the spring is going I can't see, and that's were I'm having the problem
@jfndfiunskj5299 Жыл бұрын
What about taping the belt to the drum so that there is no lateral movement?
@jakebrownlow5828 Жыл бұрын
Anyone know how to change the belt on these dryers ?