how easy it is to put on a UV DTF cup wrap!
1. Clean the surface: Start by cleaning the surface where you plan to apply the decal. Use a lint free cloth and rubbing alcohol to remove any dirt, oil, etc that may be present. Allow item to air dry before applying.
2. Peel away the backing: Gently peel the backing paper off the decal. Be very careful not to touch the adhesive side of the decal, this can leave fingerprints or marks on your transfer.
3. Carefully position the decal: Carefully position the sticker on the surface. Use your fingers or a plastic card (like a credit card edge) to carefully smooth out any bubbles or wrinkles that appear. Take your time to work the decal onto the surface starting from the center of the decal and working out to the edges.
4. Apply pressure: Once the decal has been placed onto the surface use finger tips to apply pressure throughout the design. This helps ensure a solid bond between the transfer and surface.
5. Remove clear carrier sheet: Gently peel clear transfer (carrier) sheet away from surface. Work slowly to ensure you don't pull up the decal from the surface. If the decal does pull up, just push it back down and rub decal to surface with firm pressure before trying to remove again.
✨Make sure to squeegee the front and back
✨Trim off any excess parts
✨Peel off the transfer sheet
✨Place on cup & squeegee as much as possible
✨Peel off clear transfer sheet and done!
#UVDTFTRANSFER #dtf #uvdtf #uvdtfsticker