Demo of DisplayFrames classic metal picture frame being assembled with the materials that come with the frame. These materials include hanger hardware. The video demonstrates how to add artwork into the frame and hang the assembled picture frame to a wall. Small picture frames come fully assembled, large poster frame sizes are shipped unassembled to avoid excessive oversize ground freight shipping fees.
Voice Over:
To Assemble Metal Picture Frames,
take out the parts in the Hardware Pack,
Metal Frames and Materials.
A few simple tools are also needed.
To begin your metal frame assembly,
start with the A and B Corner Key Plates.
There are four sets for each frame.
Take the metal Angled B Plates with the two screws and Place it on Top of flat A Plates.
Do this for all four sets
Now take two metal frame rails and Insert the corner keys into the frame rails back channels.
Adjust and align the frame corners.
Then use a screwdriver to tighten the screws.
Assemble the Third Rail the same way.
You now have an opening for your Artwork, plus optional backing board, matboard, and acrylic window.
When adding a matboard for your Artwork, photo or poster, the matboard opening should be smaller than the Artwork you are adding and will overlap your print.
Flip the matboard over to its back. And mark the area to position the Artwork to be viewed within the opening.
Add tape to the corners secure the Artwork in place. Additional tapes can be added to the sides if needed.
When adding Artwork, photo, poster to a backing board, you can use the included REMO repositionable tapes.
When Adding an Acrylic Window Remember to remove the Liner.
Place the acrylic over the Artwork.
Slide the Artwork with Backing Board, Matboard, and Acrylic Window, face up into the metal frame.
Add the fourth frame rail, insert corner keys, and tighten screws.
Add the included Spring Clips to the back of the frame to secure the Artwork and materials.
Careful to avoid the spring from popping up
You can now add the bumpers to the four corners of the frame back to help protect the wall.
If using a Picture Frame Wire,
First Place the Hanging Hardware into the two side frame channels. Measure approximately 1/3 Down from the Top and screw the hangers into the channels tightly.
You’re now ready to add the Picture framing wire.
Loop the Wire into the Hardware Hole. Tie a Knot and loop once more and wrap the Wire around 6 or 7 times. String the Wire into the opposite hanger. Loop it. Tie a loose knot.
From the middle area, pull the Wire up a 2 or 3” inches to give some slack. This makes it easier to place the Wire onto a picture frame hook on the wall
Take the picture frame hook with a nail and mount it on the wall to your desired position. Place Your framed Artwork over the wall hanger.
If using a notched sawtooth hanger, center it into the top frame channel.
Place your framed Artwork over the notched hanger.
Your frame is now completed,
To create the perfect style and size picture frame, use our online Customizer at www.displayframes.com
Y