Hey Bob you should get you some heavy duty paint and paint the floor in your new show while it is still half way MT so the wood floor is protected and maybe get some old carpet to put over the painted wood. Just a thought.
@matttobin14203 ай бұрын
Well . If I hand of knowin about the bleeder out thumb trick . That worked and only took a few minutes Thanks
@BisonWorkshopАй бұрын
Glad it helped
@jimspirnock11844 жыл бұрын
Good video Bob and the shop looks great.
@BisonWorkshop4 жыл бұрын
thanks
@lgj19624 жыл бұрын
I’ve had great success with filling the system using a big syringe attached with a tube at the caliper and feeding backwards (uphill) to the master cylinder. It’s a lot easier pushing the air out uphill than fighting gravity the other way. Give it a try, you can get the big syringes at a local drugstore cheap.
@ramjet74704 жыл бұрын
Pretty slick. Thanks Bob!
@thorg70614 жыл бұрын
Camera looks great nice and clear...
@connersnow2983 жыл бұрын
Awesome vid and bike
@BisonWorkshop3 жыл бұрын
thanks
@Prariedog4 жыл бұрын
Another informative video bison
@BisonWorkshop4 жыл бұрын
thanks
@100texan24 жыл бұрын
Is it hot in your workshop? I know mine is hot during the summer, all steel pipe and angle iron and corrugated tin.
@POLOAZTECA2 жыл бұрын
Hi. Need a lil help here! I got a 05 650. No brakes so I did all new calipers. Still no brakes. Just replaced master cylinder still no lock. Handle still don't seem to be doing much. Pretty lose goes all the way in! Any ideas what it might be? Thanks
@BisonWorkshop2 жыл бұрын
email me and ill give you my number to walk you through the process
@buzzsah4 жыл бұрын
did you build a new work area? Nice size.
@BisonWorkshop4 жыл бұрын
no, rent to own
@MichaelMaroon-oz9bp Жыл бұрын
I have a old Suzuki quadrunner LT250 4WD. It sat for a few years in a barn. Now, I am working to get it going. I now have it running, but the hydraulic brake handle was frozen. There was rust in the Master Cylinder so I chose to replace it. I attempted to back bleed, and cannot get any fluid through the upper brake hose that connects to the Master Cylinder. It flushes to the block where the two brake lines come off, but will not go through the hose. Is there a way to test a brake hose to know if it is blocked or swollen closed?
@BisonWorkshop Жыл бұрын
either the master cylinder is bad or your hose is bad.
@BelivingNM4 жыл бұрын
Gonna try this out been trying to bleed these brakes and no luckkk
@BisonWorkshop4 жыл бұрын
trust me. it will take the pain out of bleeding.
@BelivingNM4 жыл бұрын
Definitely helped but no dice my drizzly is a pain I'm the a$$$ needed a bleeder pump always gives me a hassle
@donaldblakley6796 Жыл бұрын
Thank you
@BisonWorkshop Жыл бұрын
your welcome
@100texan24 жыл бұрын
We need new videos. . We’re forgetting about you. A lot of competition here on KZfaq.