How to change CV Joint / Axle shaft. Volvo V50 / Volvo S40. DIY

Рет қаралды 12,273

SlavicShop

Жыл бұрын

The car is a Volvo V50 2006 2.0D

Пікірлер: 18

@volvomania1980 Жыл бұрын

Hey,another great video for the v50,thanks.

@slavicshop2398 Жыл бұрын

Happy to help ! 👏

@areksowinski9805 3 ай бұрын

Nakrętka od półosi jest jednorazowa. A tutaj kolega chyba tą samą przykręcił

@sala8704 9 ай бұрын

Well done.

@slavicshop2398 9 ай бұрын

Thank you!

@areksowinski9805 3 ай бұрын

W tym przypadku gdzie oba przeguby są padnięte to się wymienia całą półoś bez takiego drutowania. Cała półoś jest tańsza niż dwa przeguby.

@patpaft4636 11 ай бұрын

Nice satisfying video, keep it up man! Im wondering if I need to replace inner joint, because there is some play on the left axle. My main concern is some clicking noise when reducing the gear or letting off clutch to fast

@slavicshop2398 11 ай бұрын

Hey , thank you! Yes it could be , you can check by taking of and taking a look inside .

@BlakeCDS 6 ай бұрын

Same as ford mondeo mk4 thank you

@slavicshop2398 6 ай бұрын

I know that some models of Ford are the same. Thanks for confirming that!

@chrisburn7178 7 ай бұрын

I need to do mine as I just noticed it dumped a load of grease on the undertray. Except I didn't know what it was until after I'd finished replacing my control arms, so now it has to come apart again 😔 I think it's easier to undo the three nuts holding the ball joint carrier to the control arm, I took the knuckle out instead and damaged the ball joint boot because I only had a fork type remover.

@slavicshop2398 6 ай бұрын

Good luck with that!