How to Change Your Nozzle On the Ender-3 S1 Pro

Рет қаралды 9,925

7 ай бұрын

In this video, I show you how to change the nozzle on the Ender 3 S1 Pro. #3Dprinting #nozzlechange #ender3
Consider supporting the channel
buymeacoffee.com/dandesigns
(Affiliate Links -Thank You!)
Creality Ender-3 S1 Pro 3D Printer -- amzn.to/3QpJAC2
Nozzle Kit -- amzn.to/3Gsyvd8

Пікірлер: 20

@ClaudeArian 4 ай бұрын

you're a genious. Thanks!

@dandesigns3d 3 ай бұрын

Wow! I don't know about that but thanks!!

@_DROM_ 7 ай бұрын

That's exactly how I do it. I do use a rubber sleeve, thou, on the plier. I find it grips better. Now, one thing I do differently is that I test for any leakage before I place the h-block sleeve back on. Reason is that I failed once and ended with a mess just because that sleeve covered a mistake I should've noticed straight away.

@dandesigns3d 7 ай бұрын

That is a good idea. Do you just print that first print without the boot or remove it and check after the first print?

@_DROM_ 7 ай бұрын

@@dandesigns3d because my printers are in enclosures, I test the print without the sleeve. A short 30 min model does it, as long as temp is a little higher than the one you normally use. Like, 220 C for PLA.

@jeanlouismeyer9974 4 ай бұрын

Best thanks 🙏👍👍

@dandesigns3d 4 ай бұрын

You're welcome!

@EDN58yt 3 ай бұрын

How do you get a software update? mine doesn't looks like yours, also if u can, can you make a video tutorial please? btw nice video help to change it , and hope works well hahaha

@dandesigns3d Ай бұрын

I made a video on updating the firmware on the Ender 3 S1 Pro. Here is a link kzfaq.info/get/bejne/fauKntqcqarKYZs.html

@KyleAndersonSkates 7 ай бұрын

what firmware are you running? mine doesnt have that breakdown of the auto bed level like yours and i'm super envious lol

@dandesigns3d 7 ай бұрын

I'm on 2.0.8.28F4. I had to log into creality cloud to find it.

@dandesigns3d Ай бұрын

I made a video on updating the firmware on the Ender 3 S1 Pro. Here is a link kzfaq.info/get/bejne/fauKntqcqarKYZs.html

@Rabman416 7 ай бұрын

i would recommend you remake this video. Holding your heater block with needle nose pliers is a no-no. Look at your video when you are putting it on and you will see your heater block twisting. Much better idea using a wrench on the heater block.

@dandesigns3d 7 ай бұрын

Thanks for watching. It's pretty hard to get a wrench on it without disassembling. The pliers work fine you just have to apply pressure opposite the socket wrench. See 3:03 the pliers actually tweak the heater block the opposite direction of the socket wrench. That movement is not much or harmful and will happen with a wrench too.