Great how to video! I haven't replaced my heim joint bearing in years. This video is a good refresher. Another tip I use is to put the bearing in the freezer for a bit before installation. It eases installation.

Nice to see that you take your time and great care of your equipment. Detailed but yet simple enough to complete the task. Great video T4S

What a great camera perspective. Such quality. I have never seen such a descriptive video. Keep it up. Subscribed.

Love your how to videos, so indepth, and no skips, on important sections :)

In new to your videos and I'm liking them keep then coming ;) I'm subscribed to you

Great Video JoeJoe. Well explained without being too lengthy. I understand you became aware of the shagged out joint from a knocking sound in your recent vids?

No worries dude, we need more people like you! 👍🏼👍🏼

Nice s15 in the back mate, and mad video too :)

Hi there, great vid very helpfull but in my all balls kit there are 2 rubber seals which I did not see you install... Do they go in straight after the bearing? Also which way around? As they are Groved on 1 side and flat on the other? Thanks.

Hey mate, great video! What editing software do you use?? Cheers mate keep up the great work

Good Vid. Just about to replace mine and swing arm bearings. Mine are total Rust.

Nice vid,made me check mine and they where worse then yours! I brought the same bearing kit £30 and fitted them,so cheers for the vid! Btw if you use a 24m socket it fits perfect and tight so u don't need to hold it! So u wont hit ur own hand lol,i also had to heat it up as it wouldn't move to start with,cheers Dan

King Carl Thanks! Nah, this job was pretty easy actually, but yes, in reality it took about half an hour or so to do it from start to finish.

Good to see you are wearing your Japanese safety boots ;) do you use the trials tyre all year round ?

Thanks for the video what size tank is that?

Thanks for sharing,I almost pulled my swing arm cause I thought the bearings were shot but it turned out to be just the shock bearing,I made a nice puller with a piece of threaded rod.

awesome vid!!

Good stuff!

Good job. That video was 9min but how long did u actualy sit there? Lol like me it would be a couple of hours!

What is the background music if ya don't mind me askin?

Nicely done. Not a fan of all balls though, had bad experience with their products in the past.

Mine after replacement is good up and down but when I hold the shock it roles side to side is that normal

And to add there are more seals in the packet then u need,use the ones with the metal coating, the others must be for a different model,cheers ⬇️

Nice s15!

Stone the crows mate, thanks!