description
How to check the ignition path of the Yamaha Mio Karbu by first checking the color of the cable and its function from the road spool and the fulser:
1. Blue line white wire as a path from the pulser which functions as a positive pulser that goes directly to the lower right CDI socket.
2. The white wire with the red line is the path from the pulser which functions as the negative pulser which goes directly to the lower right CDI socket.
3. The white cable acts as the charging current for the battery that goes directly to the kiprok in the upper right socket.
4. The yellow wire, the red line, is the lighting line that goes directly to the kiprok in the lower left socket.
5 while the black wire is used as a road spool.
Then make sure there must be an output current from the kiprok in the lower right socket that goes to the ignition.
After that check the cable path and the function on the yamaha mio CDI:
1. The white wire with the blue line goes directly to the CDI from the positive pulser at the bottom center.
2. Red line white wire that goes directly to CDI from pulser
Negative below right.
3. the brown cable on the yamaha mio CDI is the battery current or 12 volts after the ignition is on, and make sure there must be a 12 volt current.
4. The black cable whose position is in the top center is the time or ground for the yamaha mio CDI and make sure it must be attached to the motor body.
5. The orange cable is the output line from the Yamaha Mio CDI that goes to the coil. And make sure there must be an ignition current.
Thank you to all #SUBSCRIBER# and viewers, hopefully the knowledge is useful.
Please #SUBSCRIBE LIKE COMMENT AND SHARE#
SIDIK NURYADEN CHANNEL#
If you have questions, you can write them in the comments.
Tel/WA: 085863491419.
Thank you very much.