hey buddy! I've restored my sliding one-way bearing by literally using a Dremel tool with a coarse sandpaper bit on the starting shaft (lightly). So far it has not slipped again. It was a risky trial method, but it has worked. Good work on explaining the 2 types of one-way bearings.

Good info, thank you. Pro-tip: Set the video to 1.25 or 1.5x speed

Thanks for the good video

Thanks. Helpfull vid

Good stuff brotha👍🏾👍🏾👍🏾

Great info bro!👍

yo bro thank you ive been wondering why this damn truck keeps slipping

Great tutorial video on this problem. I have an old Kyosho GS-11 engine with a pullstart that has an internal bearing (called FD24 on Kyosho part no list) The problem I have is that if I take the bearing out and clean it it works just fine. It works fine until the motor starts but as soon as the motor starts the one way bearing stops working directly. It must be that it gets contaminated with fuel and oil as soon as fuel gets into the crankcase. This is really strange since this will be impossible to avoid since the bearing sits inside the crankcase. I have also tried to grind slightly on the shaft without and imrovements. Do you have any idea what could cause this? Since the bearing works fine everytime I clean it it can`t be a bad bearing I think, could it be something else?

good video. Tried cleaning without using sandpaper/stealtissue on the starting shaft. Worked for about 2 starts and it started slipping again. Ordered new one way bearing, if that dosnt work i will try using sandpaper lightly on the starting shaft.

What's up brother 👍 💪😁👍

Ty

Ultrasonic bath works great for owb

I always did..maybe this is y it slips in fewer times

What needs to be done as far as the bearings and back plates to switch from electric start to pull start?

Do all of them face opposite of the exhaust

You don't lube your one way bearing with wd40?

Can I talk to you and solve my problem? Please Help

What partae Canada are ye from?

spraying your self with brake cleaner.... are you still healthy?