How to configure RUCKUS AP via command line

Рет қаралды 14,867

2 жыл бұрын

In this video you will see how to do necessary configurations of RUCKUS R750 AP
#ruckus #AP #wifi #wifidesign #accesspoint #cli

Пікірлер: 16

@ghasemashjaei3372 2 жыл бұрын

Amin jan kheyli mamnoonam merci

@aminsedighfar 2 жыл бұрын

Your welcome sir 🙏🏻🙏🏻🙏🏻

@flgrubbiii Жыл бұрын

Hello, I tried to reset the ruckus since the access points are not even showing the power light. After the reset the Port status mode selection button and LEDs lights keeps flashing amber, for over 4 hours by now. I connected Port C to my Mac and run the command to access the IP and keep getting "Request timeout for icmp_seq 1" ... any suggestions?

@aminsedighfar Жыл бұрын

So, it means it’s radio is not broadcasting, maybe you need to do it manually! About connecting to it, if you cannot do it, check with Ruckus support to see if you can connect to via serial connection.

@012345Dawid 11 ай бұрын

Hello do you know how to delete or disable SNMPv2 community or disable whole SNMP via SSH ?

@aminsedighfar 10 ай бұрын

Sorry for the late response. Unfortunately, I don’t know this one. I recommend to ask it in Ruckus forum Again sorry for the delayed answer.

@dnvr12 6 ай бұрын

I cant do a CLI as mine is stuck in “building unleashed network” and it will be like that for hours. Whenever i try to ssh to the ap’s IP address it will say its unable to negotiate

@aminsedighfar 6 ай бұрын

I’d say try to use the reset button by inserting a toothpick or something like this, it should work, unless I’m not sure. Maybe you need to open ticket with ruckus or ask the question in a Ruckus public q&a forum.

@nealostrander6512 10 ай бұрын

What if the 2.4ghz says Radio off. How do you turn it back on

@aminsedighfar 6 ай бұрын

Sorry for the late response. Did you try “set state wlan1 up”

@maybonifacio7869 Жыл бұрын

how to remove the Enable Auto-Update? or set to factory default

@aminsedighfar Жыл бұрын

"Enable Auto-Update" in the radio status tab? and what do you mean by how to remove it?

@aminsedighfar Жыл бұрын

If you're asking about what I've mentioned above, simply by clicking on it you can enable and disable it. But you should use your browser instead of ssh. If you are asking about DHCP and auto-provisioning, take a loot at this address : docs.ruckuswireless.com/fastiron/08.0.61/fastiron-08061-dhcpguide/GUID-72EB44F3-7508-47C6-B021-5D604D984BD1.html

@maybonifacio7869 Жыл бұрын

@@aminsedighfar or how to set to AP mode using cli

@aminsedighfar Жыл бұрын

@@maybonifacio7869 Did you try "get sag mode" ?

@aminsedighfar Жыл бұрын

@@maybonifacio7869 Also try "get ap-mode". Sorry for the late response. If your device is not either in standalone or controller mode (unleashed or leashed), you're likely not to get any response from this command.