√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

Went to y'all's website and I could not find that scanner

The scan tool link takes us to a cheap scan tool nothing like the one you used in the video and search reveals nothing better? Any better recommendations?

Does your scan tool allow to turn on the pump manually?

Mine is saying service suspension system and service tire monitoring system was wondering what you think I should check first

Hey Andy how r u doing it’s been about 10 years since Tulley. Nice to see u again. W.D.

2011 Yukon Denali xl z55, fixed the bad front driver side strut. Service suspension system still on. Will it automatically clear. Or do I still gotta have a shop clear it?

I'm chasing down a leak on the air suspension on my 2008 EXT. But on a side note damn the frame on that truck is rusted bad.

That link does not take you to the scan tool used in this video. They said it's no longer available in a comment way earlier

i was just towing my trailer and heard a pop noise.. my compressor was running very loud the last couple days now it will not raise. i suspect the compressor is leaking because it sounds like it

I feel I have a leak because recently I hear the pump go non stop and it got my attention to get it fix. Also if I have to replace the shocks which brand is the best to go. Because I heard some people say don’t go with this brand because of this 🤷🏻‍♂️ so which one is like the best to go would be awesome to know

Any recommendations on the 2021 Yukon Denali with air-ride and then setting up an equalizer hitch for trailer sway control? Anything special to setup so it levels out?

What scan tool are you using??? I'd like to purchase it.

Currently Working on this issue myself on a 2010 denali. I picked up some shocks from you guys and an air pump. both are replaced now. wired the new pigtail into the factory harness. when i first connected the pump and cleared codes, it inflated and deflated fine. after the first time i have codes again and it wont kick on. I have 2 codes C0660:06 Level control exhaust valve circuit short to ground/open (which does work if i manually toggle it while they are aired up by disconnecting and reconnecting the white wire), C0580:04 Right Front actuator circuit open. I am getting 3 ohms on the right front damper solenoid. 3 out of 4 level sensors show around 2.7v but my right front shows 1.6 which tells me i probably have high resistance on that level sensor. all terminals are clean, no blown fuses, no corrosion. vehicle does not see any winter driving. i can jump the 30-87 pins on the ALC Relay and it will inflate just fine. this is definitely a strange system but id like to get it working properly. my next thoughts are replacing that right front level sensor, if that doesnt work Maybe the ESC module? im not sure where else to turn but i do want to do a little more testing. i have all of the GM diag procedures at hand. any thoughts?

I have 2015 Cadillac XTS the rear driver’s side higher an inch from the passenger ‘s rear side!! Any explanation?? Or recommendations! Thank you

Good afternoon. Do u know how much PSI needs every shock..Thanks

you left out checking fuses?

I have a 2003 Cadillac Escalade 2wd, 5.3L with Z55 Air Ride Suspension. At least with the 2003 you can have no codes at all and the entire suspension may be off line and no blown fuses. The air compressor was not working at all. (Key on = nothing) I replaced the air compressor first as this is where you have to begin! Reconnected battery, still no codes, but with Key on = air compressor pumped! Now with air I could test rear shocks as they inflated, I sprayed on soapy water with a spray bottle on the rubber. Both rear air shocks were leaking at the bottom of the shock rubber bladder. Replaced air shocks with new that supported electronic dampening. Still no codes. But rear air shocks inflated and rear suspension raised to proper height. Then I moved onto front electronic shocks (these have no air) replaced with new shocks. (I wanted to maintain the full Z55 electronic dampening for all 4 shocks). Not necessary to maintain electronic dampening by the way, and more expensive, but the way I wanted to go. (See other 1A Auto Videos) Now, finally, with both of the front shocks replaced, I get a "Service Air Ride" message on my vehicles digital display! Went to O'Reilly's Part store. Free check for codes. What a joke! Their scanner is not remotely capable of doing what 1A Auto Parts scanner did in this video! A scanner that can communicate to GM products to test the air ride suspension is a MUST HAVE! Not all scanners can get the accurate data that the 1A Auto Tech and specifically GM Data the tech showed to us all! So, all I could do is remove the battery terminals to get the "Service Air Ride" message to reset. On the 2002-2006 Cadillac Escalades and similar Tahoe's, Yukon's and Surburban's', its common to get no codes or messages at all and have no blown fuses. 2007- and up GM vehicles had greatly improved OBD2 monitoring, had more fuses assigned and better labeled and more fault code messages related to the suspension system. I thank 1A Auto for making video's like this! 1A Auto, can you please advise on adjustment, recalibration of the ride height sensors? And more importantly too, where can I buy new replacement ride height sensors if needed? My are pretty old. Thanks !

My air ride suspension is way to stiff in the rear, is there a way to adjust the shocks? The shocks seems that they are aired all the way all the time.

Can you replace the Front Electronic struts with a conversion kit and kept your rear air shock ?

i cant talk to the electronic suspension control module with my scan tool like how u did in this video. Does this mean that its broken if so do you guys sell them pre program for my truck i have an 08 gmc yukon xl 6.2.

Hello if possible please let me know what PSI these air ride suspensions run at. I disconnected my Airline and the compressor works the pressure seemed really light. Thank you

Can you tell me what your professional opinion is about my car. I have a 2014 Cadillac XTS and the rear end lowered. This started about 5 days ago. Couldn’t get it to go back up. That night went back up and drove it for 2 days and the next morning started car and heard pump come on and the car lowered and didn’t come back up till the next day around noon. No lights on my dash and I hear the pump come on every time I start the car. Checked fuses in trunk and under hood and all are good. Do you know what’s wrong?

What scan tool is needed for this being it’s not a typical CEL

Link to scan tool doesn't work any more

I recently bought a 2014 gmc yukon denali. I'm hearing the pump go on for about 5sec every time I start up the truck, even if I turn it off for a minute then back on, you hear the pump again??

Like that reader sensor

The reason I watched the video is because my 2019 Cadillac Escalade ESV Platinum rides worse that a unsuspended hay wagon back on the farm. New tires properly inflated per the door sticker. Cadillac Dealer says all is well, I told him it's horrible ride.

So after some research, I’m seeing that the noise upon tuning on the vehicle is normal. My question now is, is there any way to make the noise quieter?

Nice review

Just bought the shocks compressor but it doesn’t turn on I have a 2000 tahoe but they sayd that chevy made 2 different styles dont know yet but my compressor is on the passengers side middle of the truck dont know what to do

Does the same test work for cadillac xts air shocks ?

Hi, I have a 2005 chevy suburban, the air ride pump comes on once in a while... not regularly like it use to do... I pulled the harness off yesterday, terminals were green, so I sprayed electrical cleaner over it, a few times, and blew air over it, and repeated till green was gone... air pump started at one point, but quickly shut off. There is power at this harness... is my pump bad? Or something else? It's no more than 2 years old, shocks as well... thanks! Steve

I have a 90 cadillac deville, I replaced my pump then burned out the replacement pump. Turned out the check valve went bad. It won,t close and hold the air in the system. It is a round brass fitting found latched to the side of the compressor. I haven't been able to find where I can find a replacement or if rebuild it i posible? Is there any insight you can give to help me solve the issue? Thank you.

Great video. I thanks for sharing !!

I changed both shocks and pump bc they was bad but still does not turn on. Unless I jump over the leads from the relay. There's no codes other then service stabilitrak and traction control lights are on the dash would those cause the system not to work

How can one tell which suspension the DTS has ?? I can hear pump in rear after I start a short while . Thanks !!

What about the front struts? Mine are stiff -can't determine what is going on

Is the pump always suppose to make that noise when you turn it on ? Every single time ? Thanks

Got a question. What about if no weight but the air compressor keeps turning on? I did replace compressor and air line.

Great video!

Step 1. Buy wireless scanner tool 🙄

Those Tahoe’s come with a air suspension? Didn’t know that

I’m glad my 5.3 suburban doesn’t have this complex suspension system . By the way i turned out lexus gx470 due to this expensive design.

Clicked on link for the wireless code reader. Didn't take me to that reader.

During a hurricane i loaded a few sand bags on my 2011 avalanche. I’ve noticed the pump doesn’t turn on any more. Do i need new pump?

What happens if I drive with the pump not working.? Lights been on for a month now .

Clicked on the for the wireless scan tool showed completely different one a wired one

I bought a 02 Escalade and t& previous owner installed air shocks in the back and the battery is slowly draining after a couple of days. I was wondering could these two be related? Any kinda of input would be appreciated.???

Not all of these don't have money to buy high-dollar equipment.

My battery got drained cuz the alternator went bad now my car Is low only in the rear The airbags in the rear will rise the car But when I cut off the car or go past 40 miles per hour the car will go back down in the rear not the front

Can't find the scan tool used in video on web site. It only shows generic scan tool that plugs up...

Is my pump going if it makes my car sound like a diesel truck when its running???

I hve a 1991 Buick Park Avenue that has a running motor when I turn the car off. How do I bypass the air ride so my battery stops running down? I have to replace the battery bc of this.

Nice video!

Hi is it possible to adjust my ride level on 2008 Cadillac escalade I would like for it to ride a little higher in the rear

That frame will turn to rust powder before anything else lol.

I’ve had an issue with my 09 Escalade Hybrid for over 2 years now. I disconnected battery and got a code. Anyhow, I bought all brand new Z95 shocks and they wasn’t cheap. I put them on and my ride was still horrible. It didn’t feel like I changed anything, matter of fact they felt stiffer. Months later I bought a scan tool and checked all the wheel sensors and they all displayed values and as I lifted vehicle up and down the values changed like there supposed to. Please can someone tell me if these new shocks needed calibrated or trim set??? I’m afraid if I continue to drive like this it will damage my new shocks from the bouncing around. Any advice on why my 09 Escalade hybrid with brand new Z95 magneride shocks is still driving rough as before please send my way! Thanks to all. 🙏

Great video on how to use a scan tool. Question though does the scan tool turn change the parts for you? Since you are so reliant on it?

That’s a solenoid on top of the shock, not a sensor.

When replacing air shocks do we need to bleed them?

My suburban has too much air in the rear air bags, can I bleed them then reset the computer?

cadillac xts 2014 front struts

Where can i buy that scan tool ??

I replaced the compressor and the rear shocks and the compressor will not power on. I checked the fuses and they are good I pulled the relay under the hood and tested it and it clicks. I applied power to the relay connector and the compressor turns on. What is preventing the compressor from powering up on start up?

Wow awesome 👍👏👏

My wife took our Buick Lucerne cxl for monthly service now the air suspension is like shut off please can you help me diagnose

Is replacing air shocks with non air shock absorbers an option?

sir my tahoe 2012 car i am drive but back left tayer poo poo is speek plese help me

what problum

Great video, thanks. Liked & subbed! 👍

Should the compressor come on everytime you start the vehicle, even without load?

greeat video

When I'm driving I have to press all the way down on my break pedel when I'm trying to stop my car and it keeps rolling

tell me sir

Waaaaaaaaay too wordy

Great video!

Is this scan tool still available? The links don't work and it's not showing anywhere on your site from what I can tell..