Visit our website at. www.comsec.ie/ Visit our online shop at. shop.comsec.ie/ This video demonstrates how to Enable and Disable Zones and other functions on the C-Tec CFP Fire Panel
Пікірлер: 25
@peterbrehaut37805 жыл бұрын
When these panels are in walk test is there a way to also disable the sounders so you could walk test the smoke or heat detectors without sounding the bells each time. This is more for testing in office areas over many floors.
@tommcmahon34532 жыл бұрын
Have you found out?
@tommcmahon34532 жыл бұрын
Is there a way to disable sounders whilst In walk test or would you need to pull the connection direct from the sounders?
@peterbrehaut37802 жыл бұрын
No not that I have found . Pull out the legs in the panel or just have to put up with it.
@TheOutdoorlife782 жыл бұрын
With the key on active ! If no alarm is sounding and I pressed silent ! Would that set the fire alarm off within the building?
@ComsecProtectionSystems12 жыл бұрын
No
@TheOutdoorlife782 жыл бұрын
@@ComsecProtectionSystems1 thank you 🙏 also should the key be on active all the time ? I believe not only emergency testing or a alarm 🚨
@perpetualintellectual20262 жыл бұрын
I have someone who called today about a general fault on zone 3 what is the most common iissue for this?
@Dime_Bar Жыл бұрын
Someone has removed a detector to have a smoke and not refitted correctly
@Dime_Bar Жыл бұрын
@Unknown2Earth yes try and reset it, if fault comes back then check that all the smoke detectors are fitted correctly.
@vincentvanwyk55222 жыл бұрын
How do I disable the entire panel.
@Dime_Bar Жыл бұрын
Discount the batteries and turn the mains off
@luf28672 жыл бұрын
Is there a way to turn this off without a key? My housing association took the key and the fire brigade came and left without turning it off (probably don't have a key).......There is no fire but it has been going now for about 2 hours and it is a Sunday so the housing is closed.
@ComsecProtectionSystems12 жыл бұрын
You can use the code 2143 and push silence
@luf28672 жыл бұрын
@@ComsecProtectionSystems1 Thank you.......Yesterday the alarm was going for 2 hours and it is linked in my flat to one of those old red bell alarms which is way too loud.........Was driving everyone in the building insane as we all have those bell alarms and they can be herd by our neighbors down the street they are that loud.......At least now I know how to turn the thing off when the key goes missing again.
@stayinkent4722 жыл бұрын
@@luf2867 do you press 2142 on the white buttons above or the bottoms on the side?
@kevinmathew1989 Жыл бұрын
@@ComsecProtectionSystems1 thank you. I'm in UK now. Same thing happened now. I called fire force. They were helpless. I saw ur comment nd try the code . It was successful. Thanks a lot
@BloodDrippnFlowers2 ай бұрын
Thank you so much asking this
@royaldhaliwal45094 жыл бұрын
How can I access a panel with a code Please let me know thanks