How to Drain Your Floor Scrubber

How to Drain Your Floor Scrubber | Advance SC750

Рет қаралды 10,365

Жыл бұрын

🤔 HOW TO: Change Water & Solution Tanks on an Industrial Floor Scrubber
Our Floor Equipment Sales Specialist, Jack Danaher, demonstrates how to change out the water & solution tanks on an Advance EcoFlex SC750 👍 It really is "as easy as that"!
Advance EcoFlex technology keeps the water & solution separate, minimizing waste of solution and creates a faster one pass cleaning schedule with no compromise on the level of clean! 💧✨
---------------------------------------------------------------
CONNECT with Atlas Toyota:
Facebook: / atlastoyota
Instagram: / atlastoyotamaterialhan...
LinkedIn: / atlastoyota
ABOUT Atlas Toyota:
Supplying Illinois, Southern Wisconsin, Northwest Indiana and Minnesota with the largest inventory of new forklifts & lift trucks in the nation. Atlas Toyota Material Handling, part of the Atlas Companies, is an authorized Toyota Forklift Dealer committed to providing quality service, premium equipment and innovative solutions for companies of all sizes. For more information on our services, visit atlastoyota.com/.
#HowTo #NilfiskAdvance #IndustrialScrubbers #MaterialHandling

Пікірлер: 3

@jimmysavage4198 9 ай бұрын

Is there a special button on this machine to get both brushes spinning? I have the same machine at work but only one brush spins. The left one. My employer said that there is a button on this machine that makes both brushes spend that I cannot locate. The machine I have though it does not have a display of any sort or buttons it's a very basic machine where you turn it on push the handle to go which engages the brushes at the same time.

@atlastoyotamaterialhandlin5665 9 ай бұрын

Hi @jimmysavage4198! Great question - Activating the Brush Switch "on" enables both brushes to spin and then when you push the "Fwd/Rev" button to propel the machine, both brushes will come on. If they don’t, you should check the circuit breakers to make sure the breaker for that brush didn’t pop out due to drawing too much power. The Circuit Breaker is a series of white caps below the operator handle and, if one is popped, it will be sticking out further than the others. You should attempt to push the white cap back in with the power turned off and then attempt to scrub again. If this doesn't work, you probably have something more involved electrically preventing the brush from spinning. Hope that helps!

@jimmysavage4198 9 ай бұрын

@@atlastoyotamaterialhandlin5665 the whole tank left open and there was some fuse buttons that had to be pushed never even knew the tank lifted up