This is one of those videos... All the info you need, no unnecessary talk around it, short and sweet and well explained for every level of knowledge. From me there is only love and gratitude. So thank you!

Finally someone that addresses a reasonable problem with this printer Im having the same problem and you sit saved me alot of troubleshooting. Liked and subscribed

Hooooray, it actually worked. It was the black cable in my case. I opened the red cable in some places which looked questionable, but it's not broken. So I just used some tape to cover it up, I didn't cut it. I soldered the black cable and used some shrink tape, then put some insulation tape around the bundle and it works again. Nice.

You’re a legend! Thank you sir!

I have the same problem with my anycubic kobra go, thx for this video, i try to fix like u do

I'm having this issue but im suspicious that its not the printing bed causing the problem but the temperature sensor on the hotend as the printbed heated fine and i'm in the middle of trying to repair my hotend. Just putting that out there in case someone else has this problem. Regardless, now that im aware of this issue, im going to reinforce the cable at the back of the printbed to help protect it against material fatigue (maybe with a spring wrapped around the cables or something. This should spread the forces along the entire length of the cable and stop it from bending at one point. As long as the cables are bending elastically and not plastically they shouldn't fatigue.

Noooo, I have no time and nerve for this right now. But thanks.

Thanks for your quick and explanatory video. I fixed the power cable by resoldering them as you did. It would be possible to fix also the black double cable that goes into the main board?Or ti would be better to avoid messing with such thin things?

I changed both cables and motherboard and still get that error. Temp goes from from a range between 60 to 70 and error comes up again..

Damn, I hoped this will be something easier to swap out than that 😅 Btw, do you know what gauge the small wires inside the black one have?

Hi; in my case all 2 red cables and the black one all broke; I've already replaced the red ones, but when it comes to the black one, inside there are 2 thin cables; I cutted the cable, but now dont know which one was connected; anyone know if there is some kind of polarity? thanks

Would the printer work if you just disconnected the cable? As don't use heated bed anyway.👍

I changed my heatbed a month ago. Min temp error fixed. Now I'm having same error again. There is no broken or damaged wire there. Why this is happening again?

"easy"