For Tacoma's...the truck uses "resistance" to determine if a bulb is out on the truck to warn you. The issues with LED's is that they draw far less power than the standard bulb which causes the truck to think a bulb is burned...thus the hyper flash. This resistance has a bit of a forgiveness layer that will allow you to avoid hyper flash up to a certain point. (may 2019 Tacoma worked fine until I added the license plate lights...then I got the hyper flash. As you mentioned though, most better quality LED's will actually come with resistors that will eliminate hyper flash but some don't. Or they will have a separate resistor part that you can install that will also eliminate the flash. (I used Diode Dynamics) Hope this helps...

Where did you purchase your headlights? I purchased mine from top gear auto sports they’ve been fine for the past year but now just the drivers side has hyper flash and they are plug and play. They function when hazards are on but when turning left they do not flash. Would you know how to fix this?

I’ve done most all of the LED conversions, including the turn signals on my 2018. I must have bought the cheaper kind because it did the hyper flash. I ended up putting the bulbs that came with the truck back in. They also appear to be brighter than the LED’s I bought. I guess that’s what I get for going cheap. I guess I got the right head lights and fog lights because they work and look great

🤩Btw you can grab any mod you saw on my truck using the links in my description!

I have heard of this issue a lot! Thank you for the video bro.

I have an hyper flash and my front turn signals don't work now. (I upgraded to LED headlights like two years ago) On my 2016 Tundra. Where can I buy the device on your video? I was getting ready to replace the flasher.

Bought some TRD pro LED headlights for mi Tacoma sr5 23, would i have that problem?

Good video!

Thanks!

I have same headlights as you and my driver side flasher wont work, and right side works most of the time but sometimes it goes out for a while and then works again, as soon as i put my hazard lights on all 4 of the flashers work fine everytime… could you share the link for the resistors that you spliced onto your sequential turn signals? Thanks!

2:48 "Put it in your rear"? Oh... year. Whew!

That is amazing

Do you still recommend getting the headlights and LED bulbs you use or just keep the stock LED bulbs but use those headlights you have?

I have install the same headlights and my question is if the lights come on when lock and unlock the truck, because mine don’t

Sorry, but it was aggravating me, but there is no "i" between the g and n in signal.

So besides inexpensive LED's, do yo think your problem was the wiring?

What is up you guys Teeota Let’s get right to it