How To Fix Low Idle RPM Honda Prelude, Clean Throttle Body and Idle Air Control Valve. These are the first things you should try if you have a rough idle.
Пікірлер: 41
@tabasamashfaq16804 жыл бұрын
Thank you for the video bro really good quality and in depth detail. Thanks again bro your a 🌟
@animalanimal79392 жыл бұрын
This just worked great! Thank you so much
@michaeldeihl5697 Жыл бұрын
Dealing with low idle at the moment it was around 400 it actually stalled on me once when I was at a red light yesterday but when idles low it starts shaking a little bit. Going to give this a try whenever I get home today.
@pdxlopez40074 жыл бұрын
Good video bro
@smevan3 жыл бұрын
man this was a good ass video
@dolnick7 Жыл бұрын
Dealing with this same issue with a 2001 CRV. I was hopeful that doing what you did was going to fix it, but after cleaning the throttle body and replacing the IACV with an OEM Denso and adding a new MAP sensor, the low idle still persists. Fuel trims rule out a vacuum leak. Going to try cleaning the throttle body this weekend and hopefully find some blockage that I'd previously missed. I'm certain what you posted is helpful for those merely suffering from a dirty throttle or IACV.
@ponciano117navarro24 жыл бұрын
Do you have to bleed the system after cleaning? Allot of other videos I’ve watched they didn’t bleed the system
@betterviewministriesb.v.m20843 жыл бұрын
How did you get your bar off? Looks like it takes a allen wrench?
@raizlyrix16793 жыл бұрын
Hey mate, Where'd you get your spoiler? I've got a black 1999 Vtir
@hserieshooligan19972 жыл бұрын
Hey what spoiler is that cool prelude btw
@tylerthomas92602 жыл бұрын
Hey bro I pushed that mesh in to hard and it’s not popping out it’s in dented. And my cars dying even more now any way to pull the mesh out
@ChrisKingAngling Жыл бұрын
Trying to remove clamp that holds pipe on throttle body. The nut for the clamp is hidden at the bottom facing back of engine. What size nut is it? I'm blindly trying to get a socket on it without much luck.
@ChristianHernandez-hw6yp2 жыл бұрын
Where did you get the part from
@kale6643 жыл бұрын
Why did my coolant come out of the hose and not the run off valve
@Teknakill Жыл бұрын
Seriously do this guys...Buy or use a micro sonic cleaner (with heater option) and do a proper cleaning, all it takes is grease cutting dish soap and tap water. It will work for many other parts! Should have seen how my hood latch turned out too! The high heat of the water will dry fast and it will be thoroughly cleaned right!
@chiefstabahoe2 жыл бұрын
That ain't dirt fellas that's carbon build up
@dredarko8174 Жыл бұрын
What spoiler do you have
@Goon51034 жыл бұрын
All I did was loosen and tighten back up the throttle wires it kept going up and down at first
@besar2black361 Жыл бұрын
yo i did this today and now my gas pedal is loose what did i do wrong ?
@Goblin23312 жыл бұрын
Yo bro, where did you get your spoiler? I been looking for one like yours and can't find one
@josephpinheirovideos212 жыл бұрын
Came stock in some SiR & Vtir models in NZ
@jeremygonzalez91643 жыл бұрын
What is that breather filter connected to
@Teknakill Жыл бұрын
The valve cover?
@Hardcoreforliife4 жыл бұрын
Is it okay to have coolant spill, might fuck around and do this . Hopefully my car does not explode since i am not mechanically inclined lol. Have a 00 lude with p0505 and p0420
@josephpinheirovideos214 жыл бұрын
yeah well you could put a rag under it but it shouldn't do anything bad besides leave a little mess
@Teknakill Жыл бұрын
Syphon the coolent out (from the rad cap) until its below the line level you are trying to undo....and then just put it back in when done, simple as that.
@xtrongarage96664 жыл бұрын
Is your Prelude still idling normal after all this time? My Prelude is starting to have a low idle issue just wanted to know that it's solve the problem permanently? Any guidance will be much appreciated thank you.
@josephpinheiro96674 жыл бұрын
Yes for my car it did work permanently, maybe your cars running too rich or lean
@abloke123 жыл бұрын
Disconnect both battery terminals put headlights on to drain any current, replace the terminals of the battery + first. Then start the car with all accessories off, and if manual do not depress the clutch, let the car idle for five minutes, and then drive it for about 20-25 minutes, then the ECU will memorise how you drive.
@franciscomoncada68254 жыл бұрын
After completing this process, my car now idles too high, around 1200 rpm. I bled the coolant system as well. What could be causing this?
@josephpinheirovideos214 жыл бұрын
did you plug in the idle air control valve correctly?
@dannyr33463 жыл бұрын
Definitely didn't need to crack your bleeder screw for that tiny bit of coolant loss.
@waynekaleb42473 жыл бұрын
i realize it's pretty off topic but does anyone know a good site to stream newly released series online ?
@santiagocassius7753 жыл бұрын
@Wayne Kaleb i dunno lately I have been using flixportal. just google after it:) -santiago
@waynekaleb42473 жыл бұрын
@Santiago Cassius Thank you, I signed up and it seems like they got a lot of movies there =) I really appreciate it!!
@santiagocassius7753 жыл бұрын
@Wayne Kaleb Happy to help xD
@endlesstwisties4 жыл бұрын
Very risky cleaning that with a paper
@Teknakill Жыл бұрын
Dude, paper is carbon, don't panic.
@markpunongbayan51792 жыл бұрын
Your car is overheating bro
@FixofNicksMix2 жыл бұрын
I'm glad someone else noticed it was making me cringe