Im fixing up a power mac 6 with the same engine. Beutiful cylinder and piston. I even did a little port work on it. Cases are minty too!

Donny, I know you said you didn't want to keep going and bore us all, but I can't think of a better way to spend time than with an endless pot of dark coffee and Donny Walker Chainsaws!👍💪

Thank you Donny your honesty means the world!!!

Happy New Year Donny. Thanks for doing these videos especially for the carbs. Can never learn too much about tuning them

Have a Blessed new year Donny and family . Nice to see videos on the vintage equipment, and issues with newer saws .First time to get mine going today, MM35 ,from a bucket of collected parts. Sounds like a hungry mosquito . Revs well 14" bar. can be a great arbor saw.Crazy to turn on KZfaq and see you working on what is on the bench at home .

Great video! I have one of these apart! Thank You for sharing your knowledge.Happy New Year, watching your saw video's and other's keep my mind off other things!

Thanks for the videos, Very helpful, my Mini Mac has a Walbro MDC 3.

Great video, Donny, thank you!

Great stuff, happy New Year!!!

Donny another interesting show 👍 Happy New Year Johno

we are all getin old back in the 80s i had yam IT250 /// id have a hard time geting a leg over one now

They used Zama M1-M7 and Walbro MDC 16 carburetors I believe. Could you please put this series of Mini Mac videos into a playlist?

I love this video Thanks So Much Donny!!!!👍👍👍👍👍👍👍👍👍👍👍👍👍

Happy new year to you and yours buddy 592 will be out to you soon.

Great job, can a old diafram be restored by soaking in gas oil mix?

Thank You

I have a mini mac 110 that wouldn’t run when I got it unless I manually poured fuel into the carb. I took everything apart, cleaned the carb, installed new gaskets, diaphragm, and needle. I also put in a new air filter, fuel filter, fuel lines, and line adapter. Now it’s all back together and I just can’t get it to run right. It’ll start maybe once out of every like 20 pulls then dies after 3-8 seconds. Through adjusting the carb I was able to slightly improve this but it still isn’t right and I feel like I’ve tried every range of adjustment from lean to rich and everywhere in between. I cleaned the spark arrestor/muffler when I had it all apart so it’s not that. Do you have any advice? I just want to finally cut some wood with this neat little saw.

Saludos.Don!!!

thanks again

I’m working on a 110, it’s got a bad coil does anyone know of a modern replacement for it?

Getting old is crappie but beats the alternative maybe lol

😮 mantapp

Hello donny or anyone. Does anyone know where or how I can purchase a carburetor rebuild kit for a mini mac 25 and a mini mac 35. The 25 has a MDC-1 carb and says 5-441-6 chainsaw model 600093C. The 35 says MDC9-2 carb and other side says 5-441-3 chainsaw model 600091H.

zama carb

👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍