Thanks for the video man. My new ignition switch is like the one in your video but my old one was completely different. I could not have done it without this video.

This just solved a big issue for my jinma. Thank you so much! I'm glad I bought my backhoe from you fine folks!

I used this video to replace the ignition switch in my Yanmar YM1016D.

FYI: Posts: 1-power(2wires green+purple), 2-accessory(red), 3-glow plugs(smaller green), 4-starter(white)

My color pattern for the ignition switch is just a little different I have a yellow wire and only one small green wire which I think the small green one is a glow plug wire. Do I hook the yellow wire to number 1?

Hi.... I have a farmpro 2420 with 4 wheel drive. I have a problem with the driver gear for the transfer case. I took the inspection cover off the right side of the gear box were the forward and reverse shifter saft goes in. It is the gear above the transfer case. It has 14 teeth. The shift that is on is around 30mm diameter i couldn't measure it that well in the tractor. The parts book I have isn't vary good. If someone knows the part number that would be great if you could pass it on to me. Thanks

thanks

I have a Jinma 254. Mine also seems to have an extra wire (pink) connected to the starter along with the white wire. any idea what this is for?

Ki bal disw