How to Install a Sidewall on a Standing Seam Roof: SMI Detail SW3

Рет қаралды 6,494

Күн бұрын

Learn how to install the Sheffield Metals SW3 standing seam metal roof sidewall detail in this video tutorial.
**********************************
A sidewall flashing helps a standing seam metal roof panel run terminate at a horizontal wall. In this video, Jason from the Sheffield Metals Technical department demonstrates how to install the Sheffield Metals SW3 sidewall detail from start-to-finish.
Choose a profile and download your standing seam installation manual here: bit.ly/sheffie...
Please note the installation details and methods shown in this video are for reference only. Sheffield Metals recommends following their published installation details or for WTW projects following the required details issued and marked approved for that specific project.
**********************************
FOLLOW THE SHEFFIELD METALS TEAM
► / sheffield-metals-inter...
► / sheffieldmetals
Visit Our Website: hubs.ly/H0bFCn60
Subscribe To Our Blog: hubs.ly/H0bFYvX0

Пікірлер: 6

@Spacepeanut80 4 ай бұрын

Thank you, good work

@undaware Жыл бұрын

Thanks guys. About to do my roof and it all helps.

@TheMetalRoofingChannel Жыл бұрын

Good luck with your project! -Thad

@apisglider9 7 ай бұрын

How would you make this work with lap siding? Thanks

@lauramines4297 6 ай бұрын

Take off the siding run the underlayment up the wall, install the sidewall flashing, backstrip with 6” strips of underlayment, then install siding back over it. Counter flashing defeats the point of a concealed fastener roof system and doesn’t look as clean.

@mr.g937 Жыл бұрын

I'm no expert, but this seems awfully complicated. Is there no way to fabricate your panels such that the panel adjacent to the sidewall is either wide enough or breaks at a point where it can run up under the siding?