How To Install Base Trim For Metal Siding & Metal Wall Panels [Includes Cutting & Finishing Corners]

Рет қаралды 62,897

Күн бұрын

Learn how to install base trim on a metal siding installation. Step by step instructions that show you how to cut and finish base trim at the corners of a metal siding installation. With this installation method you will have clean mitered edges.
00:00 How to install base trim for metal siding panels
00:47 How to cut base trim for metal siding
04:03 How to cut opposite side of base trim for a metal wall panel
If you already have not purchased your metal wall panels give us a chance to bid your job. Save 15% to 50% with our manufacturer direct pricing and great customer service. Inexpensive delivery on metal wall panels anywhere within the United States.
Visit Our WEBSITE
www.westernstatesmetalroofing...
Visit our LEARNING CENTER
www.westernstatesmetalroofing...
If you have a metal siding installation or have a metal wall panel then you will likely need to install base trim. The trickiest part of the installation is cutting the base trim at the corners of the building. We will walk you through all of the steps so that your metal wall panel installation comes out perfect.
FOLLOW US ON SOCIAL MEDIA:
FACEBOOK: bit.ly/facebook-wsmr
INSTAGRAM: bit.ly/instagram-wsmr
TWITTER: bit.ly/twitter-wsmr
LINKEDIN: bit.ly/linkinin-wsmr
HOUZZ: bit.ly/houzz-wsmr

Пікірлер: 14

@111crazed 5 ай бұрын

On that wall tag you should of cut it on a 45 down the the bottom then fold that bit you left on the bottom down flat, it helps cover the little pin hole that always happens when mitre around a wall.

@FlatRoofAddict Жыл бұрын

I put the edge of my square on the flap you bend in and clamp it. There is more than one way to skin a cat though. Great video.

@jimraffa1777 10 ай бұрын

Great job 👍

@bevandashwood1030 2 жыл бұрын

Great video I should have watched it 10 years ago

@HaggisPower 3 ай бұрын

What function does the base trim perform, other than look good (thinking about vertical panels)?

@charlesviner1565 2 жыл бұрын

thanks for the video 👍

@1636patriot 28 күн бұрын

Do I need to do that if I have the "deluxe " corner trim that covers over that?

@cammccarthy686 2 жыл бұрын

On your fold if you used your greens you would have had a cleaner and easier time folding it because the green pushes it in the direction you want it to go. You'll notice with the red it actually pushes it the opposite way.

@JordanSteinert 2 жыл бұрын

What’s the total length of base trim needed to make 2 outside corners (of a shed) that has a 10’ run? Ie do you make your cut at 10’ or do you add 2” on each side or another length to accommodate the corner? For example, 10’ run should be cut at 10’ 2” to accommodate a square building like a shed. Thanks!