Aww man, great videos! Why did you stop making them? Missing part 4 in this series...

Hey, if you don't want to go through the firewall, a good alternative I've found is routing the cables behind the body panel that's just in front of the driver door and making a hole with a drill just before the door frame, make sure you deburr the hole, remove the interior panel on the other side and add some silicone to seal it shut.

According to F1 Schema your signal in and out look wrong check socket pins and if you match them Pin5 from module goes to Pin5 cs socket and Pin6 from module goes to Pin 4 cs socket.

Dude where can I find the wiring diagram?

I did this installation using a rostra after market switch. So I did not have to mess with getting a steering wheel With cruise control switches or clock Spring

is it possible that the instrument cluster in the job cruise equipped vehicle is not able to flash the "speed control light". According to the diagram I have spliced the correct wire without success, additionally I have put 12v to the wire to manually turn the light on but it does not turn on.

No, there is nothing to program. The servo contains the cruise control's computer.

Here is a link to the Focusfanatics forum thread about this. The link to the pdf is on page 2 but the document doesn’t seem to exist anymore. www.focusfanatics.com/forum/general-technical-chat/277656-help-me-make-how-making-your-own-wiring-harness-cruise-control-smart-people-wiring-diagrams-apply-within.html?amp=1

Well i guess part 4 is not going to be uploaded....

Hello.. you said in your video that you were going to make an installation video, is it possible that you upload that? Thanks in adavance Mihalis

So where exactly would you plug in the Add-A-Line Fuse to?

Hi, I have a UK specification ST170. I have recently bought an OEM cruise control kit that fits the 2.0 Zetec engines (compatible with the ST170) and have had it fully fitted by my mechanic. Unfortunately the cruise does not work and my mechanic thinks it is a wiring issue. Is it still pin 28 on the ST170 ECU that my mechanic should be connecting to for the speed input? Could you give me any ideas as to what would be different in installation to a standard Ford Focus? Thank you in advance.

does the car have to be programed to accept cuise control

Is this guy still alive?

do you have a link to your focus fanatic post

non cruise equipped*