How to Install Rock Slide Engineering Next Gen Step Sliders on a 2022 Jeep Wrangler

No video

How to Install Rock Slide Engineering Next Gen Step Sliders on a 2022 Jeep Wrangler

Рет қаралды 7,498

Күн бұрын

Shop Rock Slide Engineering Next Gen Step Sliders: realtruck.com/...
In this video Klay shows you how to install your new Rock Slide Engineering Next Gen Step Sliders on your Jeep JL Wrangler.
Rock Slide Engineering Next Gen Step Sliders are designed to be a true rock slider. These step sliders provide a drop step that swings down when the doors open, and then will tuck back under the vehicle when the doors are shut. The Rock Slide Engineering Next Gen Step Sliders are constructed from 3/16" steel and are finished in a textured black powdercoat to protect against scratches and corrosion. These step sliders are powered by a single heavy-duty motor, making the operation quiet and maintenance free. Additionally, these step sliders are built for mild to moderate trails and can act as rocker protection while off-road. The Rock Slide Engineering Next Gen Step Sliders will come with vehicle specific mounting hardware and most installations require no drilling. Comes with a limited lifetime warranty on the structure themselves and a one year warranty on the finish.
0.00 Start
0:14 Tools needed
0:46 Install Start
31:20 Conclusion
Free shipping for orders over $100!

Пікірлер: 8

@scottparsons4935 Жыл бұрын

This video is SOOOO much better than the manufactures video. Thank you!

@XPLSV357 4 ай бұрын

Great option for my 4' 11" Wife getting in and out of the Gladiator (4" lift, 37" tires); install was fairly straight forward...Rockslide Engineering has updated their installation instructions, so check those...the order of the steps has changed. I have had zero issues since the installation, which I did myself. Easier access for the height challenged and still offer protection to the vehicle while on the trail.

@DinkAround 4 ай бұрын

Way better that the LJ install. LJ they give you a harness for a 4 door that's way to big. You have to cut to make it fit nice. They also tell you to drill a hold in the dash panel instead of offering a nice bracket for the switch. Wish they could put some care into the LJ/TJ stuff, but I'm sure they will drop the line before making it nice. But for 2K you think it would be this easy.

@chris6131 8 ай бұрын

Do not completely remove the frame bolts. The tack welds that hold the nuts on break loose pretty easily. If you completely remove the bolts good luck threading them back in. If there are threads holding the washer on, just file the threads down and leave the bolt in as you do this.