This video will show you how to install the kumo touch™ wireless controller along with the kumo cloud® wireless interface.
Пікірлер: 14
@RandyEnglund3 жыл бұрын
This video is very helpful, because the Installation manuals say nothing about removing the cap on the wireless interface to plug in the receiver.
@alexreyes807 Жыл бұрын
How do you unmount the wireless device from the wall plate, I can't seem to find a video that shows this and I don't want to brake the device.
@dhawthorne1511 ай бұрын
Is this recommended for the mini split ?
@markboyes4143 жыл бұрын
How do you connect the Kumo Cloud to multiple thermostat's which are on their own zone? Surely you dont need to buy 3 Kumo wireless controllers?
@johndeerrm3 жыл бұрын
You have to buy one per indoor unit.
@maikwho3 жыл бұрын
I’m just looking into this too. I have 4 heads in my house so thats a big expense. I did find the wireless station that looks like it goes on the condenser outside and it can control all of the units inside. It’s still about $600 though.
@peterbtax2 жыл бұрын
@@maikwho Can you share the name or model of this? I have enough indoor units that this approach would be preferred.
@Chetecoy2001 Жыл бұрын
Needs more about MRCH2,to reset the t stat ,said WAIT
@bullboss7698 Жыл бұрын
Where do you mount the receivers? Surely you don't just let them hang there.
@alexreyes807 Жыл бұрын
Mine is connected to my air handler
@pilas30004 ай бұрын
I request a video: ‘how to turn off air handler fan.” I have a Mitsubishi Hyper heat with SVZ-KP36NAMX air handler. On thermostat the fan is set to “AUTO”, but it runs non-stop 24 hours a day and it makes weird noises (sounds like gusty winds inside the air handler) and it blows cold air through all vents whenever the condenser is not operating. This defeats the purpose of keeping the house warm. I think that if the condenser is not active the air handler must not run more than 2 minutes. Any thoughts anyone?
@NativeTexan12311 ай бұрын
My receiver is just stuck on WAIT even after resetting and reconnecting multiple times : /
@ew426511 ай бұрын
Same. I sent an email to Mitsubishi customer support. I'm not sure if you need the Kumo PAC unit as well as the receiver and remote or not. The directions do not mention it but this video shows one being used.
@NativeTexan12311 ай бұрын
@@ew4265 I have both the wireless receiver, it's remote "connector" and the wireless interface box too. It just stays stuck on WAIT...I've google into the unknown abyss trying to figure out what I'm doing wrong. The instructions are piss poor for troubleshooting.