This is how to link and sync an Evinrude or Johnson outboard engine. We need to sync the carburetors, adjust the timing pointer, set the pickup timing, idle, and WOT timing. This is the BEST way to tune your boat's Evinrude/Johnson outboard engine. OUTBOARD TOOLS USED ↓↓↓↓
PLEASE DON'T SKIP STEPS!!!
Timestamps
0:00 Intro
0:55 Checklist
1:16 Sync Carbs
3:07 Timing Settings
4:30 Set Timing Pointer
7:24 Set Pickup Timing
8:24 Set Idle Speed
9:40 Set WOT Timing
13:11 Test Run On Water
13:28 Outro
Previous Videos:
➤ Evinrude Outboard Timer Base Replacement: • Evinrude Outboard Time...
➤ TDC Tool: • How To Make An Outboar...
➤ Throttle Amplifier Tool: • FREE Secret Outboard T...
Outboard Tuning Tools:
➤ Timing Light With Built In Tach: amzn.to/3dFa66a (BEST FOR OUTBOARDS BUY IT!)
● Timing Light: amzn.to/3hsCFVv (Used In Video)
● Laser Tachometer: amzn.to/3qHbpa5
● Tachometer: amzn.to/3jF4T1O
● TDC Tool: amzn.to/3hM6dh9
Evinrude Outboard Ignition Parts:
● Stator: amzn.to/3yfLkkX
● Timer Base: amzn.to/3dEiQcR
● Power Pack: amzn.to/2Ugw7RU
● Coil Pack: amzn.to/2Ujt9MC
● Spark Plugs: amzn.to/3hM7TqX
This is a 1986 Evinrude 150 XP V6 Crossflow outboard.
As an Amazon Associate I earn from qualifying purchases.
Disclaimer: Matt's Shop is not responsible for any mechanical or bodily damages that result from performing these procedures. Moving engine parts can cause serious bodily injury. Be careful if you set the WOT full advance timing on your outboard engine. The flywheel spins at over 5000+ RPM. This can be very dangerous especially on a boat that goes 60+ MPH.