How to make 303-507 crank timing peg for ford/mazda 2.0 and 2.3L engines

Рет қаралды 16,240

5 жыл бұрын

Went to buy a special tool to time my engine and was disgusted with how expensive they were. So I decided to make my own for less than $10.00. And it works!
If you are not handy, buy it here: amzn.to/42tfeRM
Thanks for watching! Dont forget to subscribe!

Пікірлер: 9

@Delta3111 4 ай бұрын

Good knowledge 👍

@badboyjose71 2 жыл бұрын

That's slick bro thanks 👍I'm working on one 2.3 mazda 3 I don't have the tool to hold crank and saw your vid and it really help me out as for the cams I made my own tool a peace of aluminum stock and 2. Nickels to hold cams straight I'm hoping this will get the job done and I had to replace pistons 2 of them had holes in them from old valves that broke long story. But ya thanks 🤑

@tinkerscorner54 3 жыл бұрын

Cool. Thanks

@markweiss5152 Жыл бұрын

The length needs to be 38.55mm or 1.5 inches, not including the head. For the crank to stop a TDC. Do not use this tool to hold the crank wile torquing pulley or flywheel bolts, you may bust out the side of your block where the bolt goes in.

@2003pblakey Жыл бұрын

Its designed to set TDC, not torque crank bolt. you should have another tool to do that as I did. There are other videos on how to properly torque bolt down. This one is designed to set timing.

@mixingasnhaulinass 2 жыл бұрын

That's awesome man thanks, can it be used when the motor is in, like when just changing the head gasket

@2003pblakey 2 жыл бұрын

Correct. Thats its perfect for that and you will never have to worry about the bottom moving on you while its apart

@salesnetwork6739 4 жыл бұрын

How long is it? You don't even need to machine the bolt down.

@2003pblakey 3 жыл бұрын

same exact length as the 303-507 crank timing peg you can buy. i didnt have a machine to bolt down when I made it. just a pair of vise grips and a angle grinder with the sand disc blade. use a table or bench for stability. I do not recommend this method if you do not have stable hands. Timing peg itself was fit tested as it was made.