Apologies, I don't (actually used to have an MOX6 but recently sold it 😫 for the MODX). If you go to the support section on the yamaha website all the data list and parameter manuals are there where you should be able to find the information. Tbh most of the CC values should be the same e.g. 74 for cutoff, 71 for resonance etc

@@splootyvision I did it, thanks for the guidelines, I just set the cc values to match the mox6 factory inputs and is working beautifully! Appreciated your videos!

@@charlosrojo Excellent news, glad you got it all working 🙂

Sorry not sure if I fully understand. When you turn it on it should show double zero at the top and no other lights should be on anywhere on the board. If you then press the first preset (button 1) that should light up and the 2 small lights above the pedals should light up. To program a preset, turn it on, press preset 1, hold down the ‘DOWN’ button for a few seconds and the ‘double zero ‘ will disappear with the green light flashing just under the word ‘preset’. Then press the ‘UP’ button green light should move across to ‘select’ - from there you can start programming what you want preset 1 to do as per instructions in my series of videos. Hope that helps 🙂

PS in addition to my previous reply, you could always also try a factory reset if things don’t seem to be working right. Hold down buttons 1 and 6 and keep them held down for a few seconds as you switch the unit on. There will be a short countdown from 09 to 00 and the decimal points will also flash. When the decimal points stop flashing and the display just reads 00 then it is all reset.

@@splootyvision I've tried many times, but when I turn it on again, holding the 1 and 6 pedal, it goes vest me other letters. It never resets. Is there another way to reset it?

@@andersonformaggini You might have an upgraded eprom or uno chip inside it. You could try 1 and 9 I believe in that case.

@@andersonformaggini As well as trying 1 and 9 for the reset, maybe a long shot here but do you have a midi cable attached when turning it on. I’ve seen reports of this causing an issue with the solution being to turn the unit on with no midi attached and then attach the midi cable once it has booted up.