How to regrease your Can Am x3 wheel hub bearings front and back. I used LUCAS red N tacky grease that I found at my local parts store. I am not a professional mechanic. 🤷♂️ Grease hub tool link: www.amazon.com/Maverick-Beari...
Пікірлер: 15
@terrystotzheim9719 Жыл бұрын
You really should have an impact socket (black) when loosening and tightening that axle nut! 30mm too!
@GoTimeUTV Жыл бұрын
I know, but I'm poor 😅. I recently got a kit but only went up to 24
@dustyfarmer2 жыл бұрын
Before removing the hub nut I make a mark with a paint pen across the castellated nut & axle so it's easy to get it back to where is was torque wise.
@GoTimeUTV2 жыл бұрын
That's a good idea. I will keep that in mind next time I do it.
@dustyfarmer2 жыл бұрын
@@GoTimeUTV With that jack your using & the wooden boards, I welded length of 2-1/2" diameter thick wall galvanized steel pipe to the jack head and now my jack lifts my XRC from the HMWPE skid plate without the need for extra packing. Use a car stand too so your not relying on the jack alone to hold the car up.
@GoTimeUTV2 жыл бұрын
I for sure need a better set up with my jack and yeah not sure how I forgot to use my jack stands I usually do though 😬
@guystinson21992 жыл бұрын
Great job, very clean work!!!
@GoTimeUTV2 жыл бұрын
Thank you 🙌
@justinbaldwin19812 жыл бұрын
What torqe wrench did you use? Since most i can find only goes up to 150 ftlbs
@GoTimeUTV2 жыл бұрын
Check this one out www.amazon.com/LEXIVON-2-Inch-Torque-33-9-338-9-LX-184/dp/B07MKSJ4SG/ref=mp_s_a_1_19?crid=11EG0ZO12WZ39&keywords=500+lb+torque+wrench&pscroll=1&qid=1652676724&sprefix=500+lb+torque+wrench%2Caps%2C107&sr=8-19&ufe=app_do%3Aamzn1.fos.18ed3cb5-28d5-4975-8bc7-93deae8f9840&wIndexMainSlot=30
@miller440x2 жыл бұрын
Unless your strictly playing in mud and water you're severely overgreased my friend and the bearings will fail prematurely
@GoTimeUTV2 жыл бұрын
Since the regrease I've mainly been riding in dirt and sand. It's almost time for me to go over everything I will make sure to check them 👍
@skeim56202 жыл бұрын
I thought to much would pop your seals out,because of to much pressure