The screws under the corners of the bar & in the wheel arches are POZI DRIVE not Phillips. The recess in the screw is slightly different angle to Phillips. If they are tight it's very easy to destroy the recess & the screw driver tip in very short order. Pozi Drive screw drivers usually have little flutes between the blades on the tip. Look at a large, #3 or 4 Phillips & Pozi next to each other & will see the difference. The screws usually have an indent between the slots for identification.

Much easier to just use the push tab connector and remove the washer hose from the reservoir. Good vid as always.

Excellent videos. Thank you very much. In my L320 from 2011 I need to replace front right wing (your video is very helpful in that respect). Is it necessary to remove fully the front bumper? Would it be enough to loosen the bumper's screws on the right side in order to reach the wing front screws/fittings? Thank you in advance for your advise.

Meant to add; awesome post, the way they should be done

Very helpful

🙏🏼 Thanks so helpful this video

Allah razı olsun esnaf adamsın

Great work

..Thankyou for the upload

GOOD JOB THANK YOU !!

Great❤

kfq

Moving camera to fast