I just replaced the bottom and upper seat covers on my 2014 C250 COUPE. Bottom just like the video . Top one requires neckpro headrest removal which on the 250 COUPE is unique not like on the sedan . Key trick is to raise the headrest fully before removing the seat from the car , unclip the 3 headrest post clips and power wire beneath post then can yank it free of the black clip on the toothed motor arm. The OEM covers and handle were almost $900 at the stealership but the final install looks factory new. Did a couple you tube videos but they are hard to find . The six white clips on the back of the upper are difficult to reattach so used 3/0 saltwater fishing barrel swivels clipped into them to ease pulling them through the seat foam to the long wire across the back of the seat . Have to remove the hard back shell but not the lower side covers and loosen the airbag to get to the side clips of the upper seat cover. Auto trim tool pops all the plastic tabs around the perimeter out. A pencil type soldering iron makes clean holes in the cover backside tube fabric to reattach the 6 white clips and at the bottom to allow access to the two final cover torx screws at bottom . Will get 3 airbag codes even with battery disco so have a tool to clear them or car will disable after 1-2 starts .

Dzięki, bardzo pomocny materiał :-)

Hi , can i fit passenger seat cover to the driver side ?they look the same . Thank you in advance