Glad it helped.. thanks for the comments! feedback always appreciated as a small channel 👌😃👍

No problem 👍

👍

Just as a follow up. Job got done actually relatively quickly with the help of my Mrs. Couldn't have done it as easily without your video. Thanks mate.

Nice one , thanks for the update! 👍👍 glad it helped 👌

Thanks Howard 👍 I never even considered that ha 👌

Glad to help 👍

No problem 👍

Arr sorry I’m not too sure! It was a while ago I did this

Thanks for the comment 👌👌

👍👍 glad it will help mate

@@diydaly I'm going to do this outside house can I take the torx from under arches then drive up on ramps and do the rest ? sorry thinking out loud lol

@@rmc5278 yeah you'll be Able to do that mate

If the chance comes up I’ll definitely do it for you 👍

@@diydaly much apresihated bro thank you..

@@Anoymus985 👍

Did you end up managing to do it? Trying to do mine and I've got the same problem, I'm pulling hard on the corners and it doesn't seem to budge

Hey, thanks 👍👍

Hmm not sure tbh, if you’ve followed all the same steps at it’s not working may be a different setup

Glad it will help , tbh I’ve never cleaned a radiator mate

Hi Harry, im fairly sure there weren't any missing, the bumper may be slightly different on this model

@@diydaly Right you are, those bolts I referred to are for the headlights. I've been watching as many vids as I could find pertaining to replacing HID bulbs before taking it on (the front fender has to be at least partially removed and those 2 bolts are covered by the fender. I did the HID replacement yesterday (successfully). I've got an. Alltrack I was most worried about pulling the fender loose on the sides by the. wheel arches but it was much easier than anticipated.

@@harryberry474 glad you got it done .. yeah not bad to do at all really 👍

hi mate, this one didnt have.. they usually just have a simple plug on the back of each sensor though 👍

Hi mate , I’ve not done any on a 2020 model but I’m pretty sure you’ll need to take the bumper off .. there’s fairly easily to get off though 👌👍

Not done one with washers tbh mate but the caps will usually pop off then you will need do disconnect the water feed pipes and connectors

I can’t quite remember with out looking tbh mate , never had to replace any myself

Do you know it already, would love to know what info you have about it! Thanks

Arr yes mate they are a nightmare 😖 we’ve had to have a few calibrated

Oh shit.... I might have seen this comment too late. I disconnected it so I hope I don't have to get it recalibrated 🤣🤣 fuuuuck.

​@adamj8099 did you have to recalibrate jt?

@@threemileallandisconnected mine multiple times n acc worked fine

hmm im not too sure tbh mate, im afraid ive never fitted one

@@diydaly no worries thanks for your help anyways!

@@HugeVictor 👍

I’m 95% sure you can mate , I’ve not tried myself ta

@@diydaly cheers probably change it myself. What would you charge for a bumper change ?

@@JamzOs yeah there not bad to do at all mate, im not really doing any jobs outside of work at the mo but most people would charge around the £40-£60 area id say

@@diydaly you was spot on £40 lol but I’m going to do myself with my pal that’s the best bit about changing it doing it yourself lol from your experience mate the lower spoiler/retainer looks the same as tsi but there different part numbers do you think I will fit the tsi on the r line bumper ?

@@JamzOs 👍 yeah it is mate I always find you tend to take abit more care if your doing it yourself too and it’s your own car! With this video I’m sure you’ll do it no problem , there fairly strait forward really it’s just a case of knowing where all the fixing points are 👌 yeah I’m fairly sure that should just swop over mate 👍