Art always has his solutions for every gun problem! Love your videos! Please keep making more!

Thank you, Art! Always nice to learn from you :-)

Another hint.....IF ( if) you can mount the gun tightly like on that vise that you show....AND....have it sit on a drill-press table surface......put a properly sized screwdriver bit ( parallel face, hollow ground) in the chuck, and bring the chuck down onto the screw with the lever arm of the drill press. That should often exert enough pressure on the screw slot without letting the screwdriver bit slip, while holding the lever down. Then turn the drill chuck.....even if you have to attach a channel lock or some kind of "lever" on the chuck.......

Had to use an impact driver for 2 hours on an Spanish Mauser FR8 because the action screws were glued in. I still had to use the impact even when the screw was 1 revolution out so stubborn was the glue in the threads.

Correct . Excellent for the bottom trigger plate screw on doubles. MUST grind ( and heat treat if needed) bit exactly to slot, including bottom shape of slot. Hammer impact driver. And know how to use it with proper rotation preload.

Thanks Art . Appreciate your Browning knowledge.

It’s a pleasure to learn from experience. Awesome video 💯

Thank you Art.

If you don't have an impact you can put a wrench on that screwdriver that might help a bit.

Love the content. Thanks.

I love watchin and learning from you. I grew up in potosi and now own a farm in Cuba. I have a question for you. I have a auto-5 sweet 16 from 1958. My question is can I put a 12 gauge barrel on it and run 12 gauge for skeet shootin or even heavier loads? Thanks guys. Ya’ll are awesome

Fantastic!!!

Couldn’t figure out how to ask a question so here goes. Can you install a vent rib on a Savage model 745? If so what would the process be? Thanks!

Hey Art, I am curious.....do they ''red'' loctite those srews in? I have several Sweet Sixteens and ( 2 Japanese models) but have not had the stocks off the Japan ones. Thanks for the tip!

What is the thread size of that tang screw?

You can hollow grind eny size Phillips down with out over heating ,macth round shanks too screw with knock 2 side off far superior too high dollar gun screw drivers I done thousands in the last40 years p.s flat punch them screws deformed or not hard plastic handles are best to smack in them slots if it's a rusted time bomb put it under water for a week work everytime.

I'm trying to get the stock off of mine, but the forward screw (ahead of the one with the lock screw) is too bunged up to get a driver on it. I'm not mechanically inclined at all so I don't have any solutions except force. Normally I'd say oh well, but now the bolt won't come all the way back and lock into place like it should, so now I'm forced to continue disassembly but with that screw being too bunged to budge, I'm stuck.

YOU THE MAN ART!