How to repair Speaker coil only?

No video

How to repair Speaker coil only?

Рет қаралды 106,130

electronics help care

Күн бұрын

Пікірлер: 44

@electronicshelpcare 3 жыл бұрын

Please visit for more diagram electronicshelpcare.net/speaker-protector-circuit-diagram-using-ne555n/

@ROOKTABULA 6 ай бұрын

1. NEVER pour kerosene or any solvent on a speaker cone! The solvent will weaken the cone fibres and result in a driver that loses it's homogeneity and will not respond the same way after that, will not match a similar driver in the same or paired cabinet. Also some cone-voice coil joints could soften when exposed even to solvent fumes. Try a hair drier and be patient. You may have to cut off the dust cap, a cm from where it is glued to the cone, and then use heat and sharp tool to work the glue and remaineder of the dust cap free. I cannot repeat this enough: Do NOT pour kerosene or any solvent on the cone!

@twentysevenproducer Жыл бұрын

This the most explained video Ive seen so far. Thanks

@jcuvier135 Жыл бұрын

Interesting to watch but for a how-to video it could really use some narration. At the very least, a few more titles to explain details like: what resistance measures should we get when checking with the ohmmeter, what are the little orange squares of tape and what are they for, etc.

@SteveM45 5 ай бұрын

4 or 8 or 16 Ω

@SteveM45 5 ай бұрын

The orange tape are for the deep and for the centric justage of the coil.

@DrFunTV 2 жыл бұрын

Luckily I got some kerosene leftover from my 747 :D

@feriolamprea5084 3 жыл бұрын

ang galing mong gumawa sir, malinis.

@CB-bo3tm 2 жыл бұрын

Pardon my ignorance on speaker basics - would like a tiny direction for my problem. I bought a 8inch 50 watt woofer (not sub woofer) about 15 years back, used it for few hours and it sounded good. I opened it today and connected it to my amplifier and it outputs too little volume. I gently pushed the cone and spider up, and the volume goes up and it vibrates well. How can I fix it? The spider feels hard... the soft rubber on the outer edge of the cone is soft/flexible...

@JM_E46 11 ай бұрын

The abswer is 15 years, if it wasnt used from what i can assume it probably just died, because its better to use them than leave them sit for so long

@nkhosinayevaz7003 3 жыл бұрын

Good next video how to make a voice coil for a 10" sub

@brunonai0 10 ай бұрын

thank you. you mentioned that 1/3 of the coil should go into the magnet hole. does this apply to all speaker sizes?

@rickybelaongtv.3994 Жыл бұрын

New supporter friend

@stevetalin6489 Жыл бұрын

If the kerosene destroys the original glue then why doesn’t it destroy the new glue. You didn’t clean the saturated kerosene off of the cone so will the new glue adhere for long. What is the purpose of the orange stickers, maybe you couldn’t see your original coil depth markings?

@rickhalverson2252 5 ай бұрын

Clean it with strong alcohol. Use epoxy.

@A6Legit 2 жыл бұрын

Is there a way to do this if the cone doesnt have a removable center cap? Gotta tear the whole cone out and do it that way?

@nelsonsaenyi9041 Жыл бұрын

Thanks for the video. But how is that 1/3 because it looks like the larger part of the coil is the one going into the magnet. Clarify.

@octymocty132 3 жыл бұрын

Where do you get the voice coils from and do they dual voice for any size sub Thank you

@A6Legit 2 жыл бұрын

Been looking myself, they sell some common size voice coil parts on ebay for cheap.

@issactian3143 Жыл бұрын

Is it okay to use hot glue, it is faster to dried

@pl519a Жыл бұрын

@@issactian3143 No..the coil can heat when playing.

@wahidtrafo6009 Жыл бұрын

Good thanks❤

@tochimkhiung7749 Жыл бұрын

Thank you

@jeremiahmulinge5544 Жыл бұрын

Thanks 🙏🙏🙏

@MdHarun-ur3xy 3 жыл бұрын

Nice video

@jerrymcgeorge4117 2 жыл бұрын

Excellent video, thank you!

@AVMstars Жыл бұрын

How to select coil

@muhammadthameem8713 3 жыл бұрын

Spider not glued

@nkhosinayevaz7003 3 жыл бұрын

Doesn't need to be glued because it is glued with the cone

@shubham9878 6 ай бұрын

Can I use diesel instead of kerosene for removing the glue?

@danielsvamp 4 ай бұрын

kerosene is same as diesel

@Engineer.Critics Жыл бұрын

coil also attached from down side to spider how apply glue there, u didnt show in video.ita tricky and difficult part. remove or apply glue to sipder with cone.