The easy way to change the pull cord on a weed eater without the spring getting away.
Пікірлер: 71
@nylesgregory21202 жыл бұрын
OMG! Thank You! Thank You!! Thank You!!! My spring went "everywhere" as you mentioned and was totally lost on fixing it. I did notice the notch in the cord wheel. Sooo thankful you made this to guide us all on a propper fix. Awesome advise. Again, thanks so much. N
@tallcook372 жыл бұрын
My pleasure!
@dankwasampson2401 Жыл бұрын
@@tallcook37 I'll try it
@Emma-cy9lp2 жыл бұрын
I have really ripped myself up trying to fix mine! That little extra tip was the game changer for me. Thanks a lot. 😁🙏
@tallcook372 жыл бұрын
Your very welcome
@drobinson0601 Жыл бұрын
This mower has been kicking for about 10 years now. Always had a short cord on it after the original snapped and other minor issues with the recoil starter kzfaq.infoUgkx-NCBSqqKJlyQ5_JGS_STpsFYihe7bmM3 until I finally had to open it up in an attempt to feed in a new line. I noticed it was all rusty and the coil was going but upon dismantling it was too much of a pain to get it all back in there correctly and opted to just get a new one. not sure why i waited so long to do so but it was a cheap, easy fix and it would have saved me hours of fiddling with the old rusty coil or trying to pull start and having cheap make-shift lines break in my hand during a pull. If yours is scuffed just replace it!
@idiocrat84252 жыл бұрын
This helped me understand how to get the tension back with pull-cord spring . Nice one, geezer!
@tallcook372 жыл бұрын
My pleasure "child" !
@Smallz2000i Жыл бұрын
Thanks man filming was great. Camera stayed on the main point the whole time 5 stars review
@tallcook37 Жыл бұрын
Thanks, I appreciated it
@Vamp_Tepez4 ай бұрын
This video needs more likes, it's the only one that is any use for the deep cover recoil. Everything else is for stuff with cups or larger radius springs which are easier. I tried the zip tie trick but it didn't work. Surprisingly the scotch tape did it.
@lordbacon49725 жыл бұрын
Thank you so much for making this video! Mine is a Senix 4 cycle gas trimmer, and while the cord mechanism is not exactly the same, it is very similar. Thanks for sharing, very helpful!
@tallcook374 жыл бұрын
Your very welcome
@jamieshorter7093 Жыл бұрын
I was getting pissed off and tired of fooling with this spring so I thank you for clearing this up for us
@tallcook37 Жыл бұрын
my pleasure
@RandyWBrown8 күн бұрын
I am pissed off! Bought new spring and that puppy blew out on me and I was/am right back in pissed mode. Hands are killing me as I'm old and arthritic.
@evanjones71172 ай бұрын
Thank you very much. How to catch the inner hook best advice. The tape works as well. Worked for old echo (metal casing recoil) trimmer. God bless.👍🙏🙏🙏❤️🔥
@Daveloves Жыл бұрын
Thanks to you I was finally able to fix my older Trimmer. Of course after I already bought a new one since i was unable to figure it out. Then their was your video, saver of the day.😁
@tallcook37 Жыл бұрын
Nice!
@wallyb840511 ай бұрын
Ever wondered what Hell is? It’s a never ending loop trying to fix your pull cord. Thank you for this video
@olivierschmitt8179 Жыл бұрын
Thank you so much sir!!! from a french guy
@rfb94892 ай бұрын
Thanks alot sir. You really saved me big time..!!!
@johannesels52884 ай бұрын
Good video, that loop through the notch was key.
@grahambumpas32132 жыл бұрын
Thank you so much for making this refurbishing an old hoffco weed eater this will help!
@tallcook372 жыл бұрын
my pleasure, thanks for watching
@lebogangphakathi0972 Жыл бұрын
Thank you for the knowledge just fixed my trimmer.
@tallcook37 Жыл бұрын
my pleasure
@gallowaykevin875610 ай бұрын
Super thanks brother for showing this illustration !❤❤❤❤😊😅😮😂😮😢🎉🎉🎉
@jesuscespedes633 Жыл бұрын
Thank you very much. This video saves my day.
@tallcook37 Жыл бұрын
You’re very welcome!
@blueyoshi92332 жыл бұрын
THANK YOU! massive help
@dedicated2WHOiLove Жыл бұрын
well that Brand has their act together! there's videos on here of other brands where a person has to take the clutch off and spindle shaft out and all hell.
@donalward3360Ай бұрын
great job -tanx 👍
@actiaint6 ай бұрын
Now, how do you reattach to motor? There is a spring loaded plastic wedge that stops the cord being pulled.
@imanhayyan9843 Жыл бұрын
Thank you sooo much! It really helps
@tallcook37 Жыл бұрын
You’re very welcome, thanks for commenting.
@raul2839 Жыл бұрын
Thank you!!! I was going crazy!!
@dondondoodle Жыл бұрын
Good video, I appreciate it.
@davehaining9830 Жыл бұрын
Great video, thank you
@tallcook37 Жыл бұрын
my pleasure
@lalthachungnungavaltea4352 ай бұрын
Good, thank you.
@markprewett21172 жыл бұрын
Many thanks Great advice!
@tallcook372 жыл бұрын
Your welcome!
@RandyWBrown8 күн бұрын
My hands are killing me from pinching and winding only for that greasy thing to start sliding through my trembling arthritic fingers as i get close,wife is at the neighbors house and ain't no pliers or tape handy..guess I'll try again when hands stop shaking, might need a cold one 😉
@raymondj8768 Жыл бұрын
THANKS BRO I WAS HAVING A HELLOFA TIME LOL
@efrenguevaradiaz1730 Жыл бұрын
gracias me salvaste la patria
@shainthomas209311 ай бұрын
Great video thanks!
@rockyd192 жыл бұрын
Thanks
@tallcook372 жыл бұрын
your welcome
@u.s.a.1982 жыл бұрын
AWESOME thank you!!
@tallcook372 жыл бұрын
My Pleasure
@Anas_A724 Жыл бұрын
خوش طريقة
@jeremiahbattey992411 ай бұрын
Good job
@hashtagbiscuits Жыл бұрын
thanks!
@Timothyis Жыл бұрын
Wow! Thank You
@tallcook37 Жыл бұрын
my pleasure
@user-qb1jo9ik2b Жыл бұрын
Slt je possède une débroussailleuse SRM302A DX savoir où se trouve durite d'essence merci
@tezn9085 Жыл бұрын
Mine will not recoil its like its backwards if that makes sense
@tallcook37 Жыл бұрын
I can't picture it; did you make sure you are indeed not winding backwards? Have you got it fixed yet? let me know. Thanks
@Alex-bjorn2 жыл бұрын
In my case the center screw does not come out, it just goes round and round but I cannot remove it, does anyone know why?..... please.
@tallcook372 жыл бұрын
Without a picture/seeing it, it's hard to diagnose what's happening there, have you got it sorted?
@quotesoftheday0 Жыл бұрын
What is brand name of your trimer?
@tallcook37 Жыл бұрын
This one was a Husqvarna.
@tylowe78 Жыл бұрын
That spring is so hard to wrap and keep in place. Keeps unraveling on me.
@adrianaghitoaie2996 Жыл бұрын
First you have to degreasse it with brake cleaner or solvant! It will help in my opinion!
@tylowe78 Жыл бұрын
@@adrianaghitoaie2996 ok
@dinotomljanovic79462 жыл бұрын
Gupi
@tallcook372 жыл бұрын
Is there a meaning for this word?
@thesuperchoober5 жыл бұрын
Your voice sounds exactly how I feel when trying to fix these damn things. Great video !
@tallcook374 жыл бұрын
Ha ha, i hear ya!
@LaughingMan445 жыл бұрын
spring on mine makes it impossible to just wind it by hand