How To Replace Blower Motor Wiring Harness 2007-2017 Ford Expedition

Рет қаралды 50,722

3 жыл бұрын

Buy Now!
New Blower Motor Resistor from 1AAuto.com 1aau.to/ib/1AHBR00086
The heat and air condition fan is controlled by a separate module, called the blower motor resistor. The nature of this component’s job causes it to heat up frequently, which can lead to failure, sometimes in the wiring. If your vents will only blow one speed, this is likely the cause. TRQ has a new resistor module wiring harness made specifically for your vehicle. This video shows you how to install it yourself in your 2007-2017 Ford Expedition.
• Check here for more videos on the 2007-17 Ford Expedition: • Ford Expedition 3rd Ge...
This process should be similar on the following vehicles:
2007 Ford Expedition
2008 Ford Expedition
2009 Ford Expedition
2010 Ford Expedition
2011 Ford Expedition
2012 Ford Expedition
2013 Ford Expedition
2014 Ford Expedition
2015 Ford Expedition
2016 Ford Expedition
2017 Ford Expedition
Tools you will need:
• Trim Tool Set 1aau.to/ocR/1AXXX00006
• Wire End Cutters
• Razor Blade / Gasket Scraper 1aau.to/oP/1AXAA00280
Subscribe: / @trq
Check out our playlist:
Ford Expedition 3rd Generation 2007-17: • Ford Expedition 3rd Ge...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 27

@TRQ 3 жыл бұрын

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

@davidsonpeguero2760 2 жыл бұрын

Tackling this tomorrow after seeing my resistor plug had a burnt out prong. So far I’ve change actuator blower motor and resistor. Now time for the plug

@TK-ff5kc Ай бұрын

Replaced a burnt plug 2 years ago, now it's starting to do the same thing again. What is the underlying cause of this continuing to happen?

@Ice0teal0ice0cream 2 жыл бұрын

It's actually really smart how you cut the wires gradually longer as you continue so you know which side is which

@MsRican143 Жыл бұрын

Hi, do you have any suggestions on the Second row AC control??? I can change the music, control the heating seats, but I can’t turn on the AC

@benchippy8039 9 ай бұрын

I bought a new heater blower motor along with the connector from a breakers yard. The existing connector has an extra wire in it and all wires are different colours. How do I work out what to do here, the donor vehicle is the same age and model yet different harnesses

@Ale-vb7dq Жыл бұрын

What’s the difference between dual zone vs manual temperature product

@sherryleake8697 3 ай бұрын

Mine doesn't look like that mine white

@arvazquez5321 2 ай бұрын

Wouldn't it be easier to replace it all together instead of splicing, or do the wires loop around somewhere deep inside, or connect somewhere else in the middle?

@ziiman Жыл бұрын

Should I disconnect the battery?

@mrsl0305 3 жыл бұрын

Is the " wiring harness" and the " pigtail" the same thing?

@cyrenthiamichael1221 3 жыл бұрын

Yes

@music_vidznocopyrightsound3969 Жыл бұрын

mime keeps over heating I've replaced is 4 times and I've replace the power motor twice and the power wire still keeps over heating

@RosaMartinez-ir4gv 2 жыл бұрын

How do I connect wires from the vehicle after they have been spliced to pigtail?

@josephnuncio1503 Жыл бұрын

Your title says "Blower Motor Wiring Harness" however what you are showing being replaced is the Blower Motor Wiring Harness, which is different from the actual blower motor's wiring harness.

@shanetrogdon9549 Жыл бұрын

My wires are different colors and i can't find a diagram

@andrewj3125 3 жыл бұрын

So I have a auto climate control with a burnt up pigtail. I think the positive, negative, and ground were 10 gauge. The signal wire is a 14 gage I think. Got the new aftermarket pigtail and ALL wires are 10 gage. Somebody said it would be ok. Spliced new one on and not working. Used a test light and nothing. Im not good with electrical or testing. Im at a crossroads. Not sure if im testing right or if I got wrong pigtail or a new "bad" resistor. Tested blower and its getting continuity. My test light would not light up on the resistor side. Confusing to me.

@jordonfiddler9434 3 жыл бұрын

Same problem I got let me know if you get it figured out thanks

@MrBoratWOW 2 жыл бұрын

Did you disconnect your battery? You may have blown a fuse if not.

@pudgymiller8952 2 жыл бұрын

Same here???

@pudgymiller8952 2 жыл бұрын

@@MrBoratWOW checked that... Fuses are ok.

@stevephillips4631 Жыл бұрын

Did you figure out what the problem was