Buy Now!
New CV Axle Assembly from 1AAuto.com 1aau.to/ia/1AACV00114
This video shows you how to install new front CV axles from TRQ on your 2005-2010 Toyota Tacoma. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.
Estimated installation time for a professional technician is approximately: 2 hours 30 minutes
This repair was done on a 2010 Toyota Tacoma Base 2.7L Standard Cab Pickup 2-Door 4WD Manual and the process should be similar on the following vehicles:
2005 Toyota Tacoma
2006 Toyota Tacoma
2007 Toyota Tacoma
2008 Toyota Tacoma
2009 Toyota Tacoma
2010 Toyota Tacoma
2011 Toyota Tacoma
2012 Toyota Tacoma
2013 Toyota Tacoma
2014 Toyota Tacoma
2015 Toyota Tacoma
Tools you will need:
• 19mm Socket
• 21mm Socket
• 35mm Socket 1aau.to/oaC/1AAST00005
• Dead Blow Hammer
• Wire Cutters
• Ratchet 1aau.to/occI/1AXAA00016
• Cotter Pin
• Gloves 1aau.to/obco/1AXSS00048
• Safety Glasses
• Soft-Bristle Brush 1aau.to/oyM/1AXAA00079
• Drain Pan
• Floor Jack 1aau.to/oaAe/1AXAA00068
• Hammer
• Jack Stands 1aau.to/oam3/1AXAA00065
• Punch
• Wheel Chocks
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.