How to Replace Front wheel bearing on Peugeot 307 / Peugeot partner/ Citroen berlingo

No video

How to Replace Front wheel bearing on Peugeot 307 / Peugeot partner/ Citroen berlingo

Рет қаралды 59,453

Guddu Pappu

3 жыл бұрын

Пікірлер: 43

@craftbrewer5401 3 жыл бұрын

Well done. That was a larger operation than I thought.

@cyberbob4111 3 жыл бұрын

brilliant illumination and filming! And I also like, how your children always find their way into the video 😀

@paulmcdonald8055 3 жыл бұрын

The Old Tappered Bearings are a joy to do compared to these ones!🙈

@ozzi3146 3 жыл бұрын

Einfach hammer deine präzise Arbeitsweise 👍💪

@elchuchogrande78 Жыл бұрын

Thanks for the video now I can replace my

@SuperKayno189 2 ай бұрын

Cheers mate

@dickyyrrep1383 3 жыл бұрын

Really good Video, thanks,

@carlwood5501 3 жыл бұрын

Good Vid but could have been better if you gave the spanner/socket/torx sizes

@SegugioGarage 3 жыл бұрын

good job!

@momoabdel5694 3 жыл бұрын

excellent travail! bravo

@paulmcdonald8055 3 жыл бұрын

Good Vid! Just before fitting brake calliper, your thinking of a cup of tea? 👍

@tompwh Жыл бұрын

Hi do you not torque the wheel bearing down? reason i ask is i have had 2 front wheel bearings fail, i dont know what is causing it, i have changed the driveshaft im thinking maybe wrong cv joint would this cause the bearing to fail? also do u not tighten the bearing with wheel on ground? or is there no need on this car. thank you

@davisscott8499 10 ай бұрын

Great video

@vlogswithwaheed 3 жыл бұрын

Good job

@Serg_87 3 жыл бұрын

👍

@alansimpson432 9 ай бұрын

Nice job, But never press from the inner race as you can ruin the bearing.

@steviemax147 2 жыл бұрын

Good video! What are the signs of a bad wheel bearing and is there a test I can do without having a lot of tools?

@ronbladon7833 4 ай бұрын

You will hear a humming noise which will get louder as it wears more. As you corner the noise increases as the load changes. Jack the vehicle up and spin the wheel...then touch the suspension spring with your finger...you will feel a vibration through the spring if the bearing is worn.

@DANCEGASMAN Жыл бұрын

Please put part numbers and links in your descriptions.

@bigshoe9130 Жыл бұрын

Hi bud. I see your well versed on Peugeots by the looks of things. Can you tell me how much gear oil a 2016 Peugeot partner 1.6 would take in the gearbox?

@guddupappu3582 Жыл бұрын

1.75 lt

@bigshoe9130 Жыл бұрын

@@guddupappu3582 thanks alot my man.

@bigpaul009 7 ай бұрын

Hi very good video, 1 question, in the whole item you took of were would you find the abs magnet ring, thanks in advance.

@guddupappu3582 7 ай бұрын

Magnatic seal on the bearing itself

@bigpaul009 7 ай бұрын

Thanks for the quick reply, much appreciated.

@gm1762 Жыл бұрын

Not bad but important small things are not shown or just bad (e. g. do not mount the brake rotors with the small screws until the axle nut is tightened)…

@lewisirvine8065 Жыл бұрын

Can this be done by keeping the oil in gearbox? I noticed slight shaft movments make it leak, and gearbox is sealed for life unit on my 3008

@ronbladon7833 4 ай бұрын

It can be drained if necessary and refilled through the breather.

@jomski85 2 жыл бұрын

I recently did my Citroen C4 which shares the same suspension, brake and steering components, as your 307. Did you end up replacing the transmission oil that leaked out? I also had leaks but I'm thinking if I should replace it, I maybe loss 100ml-200ml of oil approximately

@guddupappu3582 2 жыл бұрын

You can replace or you can just top up that is up to you