Godsteddy Bear . In order to put it in the lock position. you must push the key go toward the ignitions then twist into lock position. (Push the key further in) hope that helps you.

Thanks. I'll try that

That's a great question. If I had a hard time removing it because of a broken key I will use drill bits and drill it out near the release pin. You would definitely need to pick up a new ignition cylinder with keys.

No programming required just replace and go

If it doesn't turn with the key or has a broken key inside I would recommend to use several size of drill bits and drill it out.

If your key broken in the ignition I would get a drill and drill it out with drill bits to remove the key ignition cylinder and buy a new key ignition cylinder then install it.

In order to unlock the steering you have to turn the key out of the lock position to the ACC position and turn the steering wheel left to right until it unlocked .

I bought a new cylinder from dealer and one from junk yard before hand ome was the $25 one from junk yard and the one from dealer was 225. It had the immobilizer and immobilizer key both. Ive tried to 10 minute 5 seconds 3 times in a row. Numerous times and still my security light wont shut off and car wont start

You might have to turn the steering wheel left and right to remove some tension from it. At the same time try to remove the cylinder.

Press the button he is talking about. It wont go all the way in but as long as you hold it and wiggle the key itll slide into the next one. Then go to acc and push it all the way down

There should be a steering wheel release near the shifter that requires the key, maybe?

Mohd Firdaus Johar you have it on the lock position then you won't be able to remove the ignition cylinder key

What if its stuck on lock