How to Replace Rear Brake Pads and Rotors on Suzuki Grand Vitara

Рет қаралды 37,500

5 жыл бұрын

How to Replace Rear Brake Pads and Rotors on Suzuki Grand Vitara
#suzukigrandvitara #suzukivitara #suzuki
Deals & my Gears on Amazon: www.amazon.com/shop/hummansunson
Disclosure: As an Amazon Associate I earn from qualifying purchases
Disclaimer: NewRoad assumes No liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Please consult your qualified auto technician.

Пікірлер: 34

@NewRoad 5 жыл бұрын

Visit our Adventures Store: www.amazon.com/shop/hummansunson

@user-ds3xe7ou4p Жыл бұрын

Good job. Next time, please, also show people that you have to monitor brake liquid level in the bonnet once you start compressing the piston😊

@LG-kl3co Ай бұрын

I think you are better removing the calliper from the carrier so you can properly clean up all the surfaces where the slider plates locate....one lump of rust under them causes the new pads to stick and drag against the disc.

@KILOENDO 2 жыл бұрын

Thanks

@716OutdoorsTV 3 ай бұрын

Need to lube slider pins. Most important part

@NewRoad 3 ай бұрын

Yes, good point!

@markbrock4427 4 жыл бұрын

Thanks,I have my own to do soon,pads seem quite small compared to discs....had you any handbrake adjusting to do?

@NewRoad 4 жыл бұрын

Not at all, those work very well!

@jessymode 2 жыл бұрын

is it better to have drums for 4x4

@andrewhamilton2773 9 ай бұрын

What size bolt do you need to force off the rotor? I'd think you'd be better using two bolts together!

@NewRoad 9 ай бұрын

I don't remember the size tbh

@junybeltran4920 5 жыл бұрын

Hi nice video what size is the bolt to take the disc off??

@NewRoad 5 жыл бұрын

Sorry, I'm not 100% sure - but think it was M8x1.25 (8mm)

@keloryms8976 5 жыл бұрын

10mm

@gosho0 4 жыл бұрын

Do you have to change the pads if you are changing the disks?

@NewRoad 4 жыл бұрын

Ideally yes - but if pads are in good condition (smooth) and have enough life left, you can keep it

@zoneb609 2 жыл бұрын

Hi! Do you happen to have the torque specs for the bracket ? And slider bolts? Thank you have a nice day

@NewRoad 2 жыл бұрын

Sorry, can't find my notes. Try to search suzuki forums - some of them have docs

@zoneb609 2 жыл бұрын

@@NewRoad I tried, even have the service manual but only can find for the rear drum version. I torqued it to 85 foot pounds and it’s still there so I think I’m fine hehe

@jdbosshog35 Жыл бұрын

What size/thread bolt did you use to get the rotors off?

@jdbosshog35 Жыл бұрын

I think I found it. M8*1.25?

@jeromeswaby3896 Жыл бұрын

Do you know where u can get the handbrake shoes? Can you send me a link or part number. Thanks

@NewRoad Жыл бұрын

Try rockauto.com

@lewcarrumjohnson2786 3 жыл бұрын

I notice the handbrake was an inner drum, I assume you did not engage the handbrake for this operation?

@NewRoad 3 жыл бұрын

It should be released to remove rotor - just make sure you chock wheels so vehicle does not roll.

@OrionJGM 4 жыл бұрын

Why didn't you cleaned the caliper?

@NewRoad 4 жыл бұрын

I always recommend to clear caliper with Brake Cleaner. To be honest, I can't recall if I did this time...

@carswells6977 4 жыл бұрын

Porque não lavou as peças, as pinças de freio, estavam sujas, enferrujadas ,precisava de uma boa lavada

@zkhrk 5 жыл бұрын

Hey how can i contact you?

@NewRoad 5 жыл бұрын

humman.sunson@gmail.com

@13tomasito13 11 ай бұрын

Didn't say the start key size.

@stevenholley4185 2 жыл бұрын

This does not show rear brakes. They're front brakes.

@markbrock4427 Жыл бұрын

That is the rear.... You can see the small brake shoes inside the combined disc/drum set up for the parking brake....the rubber plug fitted to the new disc as shown is for access to the parking brake shoe adjuster cam....you can also see the separate rear shock and spring...the front has a combined strut/spring shock absorber unit.

@mariewhitley6375 7 ай бұрын

EXHAUST PIPE HAS BEEN FITTED IN WRONG PLACE THEN