How to Replace Rear Brakes 06-18 Jeep Wrangler

No video

How to Replace Rear Brakes 06-18 Jeep Wrangler

Рет қаралды 73,038

Күн бұрын

Buy Now!
New Brake Pads from 1AAuto.com 1aau.to/ia/1ABF...
Brake pads wear out over time, much like tires, and need replacing, on average, every 50,000 miles, with variations depending on driving habits and environment. Brake rotors may also need to be replaced if they are warped or grooved. Often, it’s safer and more cost effective to replace pads and rotors at the same time. Squealing or grinding noises, or wheel vibration are all symptoms of worn brakes. This video shows you how to install new, quality TRQ brake pads and rotors on your 2006-18 Jeep Wrangler
• Check here for more videos on the 2006-18 Jeep Wrangler: • Jeep Wrangler 2007-201...
This process should be similar on the following vehicles:
2007 Jeep Wrangler
2008 Jeep Wrangler
2009 Jeep Wrangler
2010 Jeep Wrangler
2011 Jeep Wrangler
2012 Jeep Wrangler
2013 Jeep Wrangler
2014 Jeep Wrangler
2015 Jeep Wrangler
2016 Jeep Wrangler
2017 Jeep Wrangler
Tools you will need:
• Pocket Screwdriver
• Pry Bar 1aau.to/ob/1AXA...
• 15mm Wrench 1aau.to/ob/1AXA...
• 18mm Wrench
• 13mm Socket 1aau.to/ob/1AXA...
• 19mm Socket 1aau.to/od/1AXA...
• Brake Caliper Hanger 1aau.to/oa/1AXA...
• Side Cutters
• 1/2 Inch Air Impact Gun 1aau.to/oa/1AXA...
• Ratchet 1aau.to/oa/1AXA...
• Torque Wrench 1aau.to/od/1AXA...
• Brake Grease
• Brake Parts Cleaner
• Cloth Rags 1aau.to/oa/1AXS...
• Copper Anti-Seize
• Rust Penetrant
• sanding disc
• Drain Pan 1aau.to/oa/1AXA...
• Rubber Mallet 1aau.to/oa/1AXA...
• Wire Brush 1aau.to/oa/1AXA...
Subscribe: / @trq
Check out our playlist:
Jeep Wrangler 2006-2018 3rd Generation JK: • Jeep Wrangler 2007-201...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Пікірлер: 49

@TRQ 3 жыл бұрын

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

@stephencarli3024 9 ай бұрын

This was the most well-thought-out and properly paced video for Jeep JK rear brakes that I have seen. Thank you also for the torque specs.

@VincenzaV1 3 жыл бұрын

Wow....Impressed! You need your own TV show my friend! Thank you!

@sallopez1655 Жыл бұрын

now he knows how to explain it well

@karcharias811 4 жыл бұрын

Awesome. More Jeep Wrangler stuff please !!!

@tonycurran2641 2 жыл бұрын

Very thorough and clear presentation thanks

@Colorado4x4 4 жыл бұрын

Do you need to bleed the brakes or add more brake fluid? Thanks for the video! It was great!

@rayss3323 8 ай бұрын

PERFECT! Thx! My e-brake doesn't hold well at all and am planning on pulling the rotor to check it out. This really helps.

@kevinpritchard3592 6 ай бұрын

Learning a lot by watching this channel. Much appreciated. Thanks

@kevinc5917 2 жыл бұрын

i always thought you put grease on the new silver parts where the pads ride on?

@jtbolton5777 Жыл бұрын

Great Vid...and a few time saving tricks. High quality cleaning process, Thanks for taking the time.

@Colorado4x4 4 жыл бұрын

Thanks a lot for this video. I replaced my brakes and rotors today and this really helped. Saved me hundreds of dollars

@douglasmorton6121 2 жыл бұрын

Great presentation!!! Thanks for the video!!!

@tysonmurphy7521 2 жыл бұрын

Great video, easy explanation. Thanks.

@calsurflance5598 2 ай бұрын

Check the owners manual! Mine says 100 ft lbs on wheel lugs. I have a 2018 JKU.

@TRQ 2 ай бұрын

+@calsurflance5598 Thanks for the feedback! 1aau.to/m/Shop-TRQ

@leonarddesrochers4390 4 жыл бұрын

Great video! Explained everything needed to know with insight, and kept it simple. Thank you TRQ

@victoramaro9290 Жыл бұрын

Thanks for sharing this video it was very helpful to me

@foxrydes6249 3 жыл бұрын

Thanks, this was really helpful doing my rear brakes!!!

@initra25 5 ай бұрын

Dont you have to pump the brakes afterwards so the calipers can set?

@jimkardas4962 3 жыл бұрын

Gold Standard Video!

@TRQ 3 жыл бұрын

+Jim Kardas Thanks for watching our video! 1aau.to/m/Shop-TRQ

@Diabloweld666 3 жыл бұрын

122 ft/lbs on the wheel nuts? I understood spec to be 95-115 ft/lbs. I tighten our aftermarket alloys to 95 ft/lbs and I've never had a problem. Great tutorial otherwise. The JK brakes are some of the easiest I've ever done.

@jbkivontop 4 жыл бұрын

on the "e" brakes adjustment wheel, what way is expanding or contacting the brakes?

@willytwo53072 3 жыл бұрын

Great job! Very thorough. Thanks.

@danieljurgill1681 4 ай бұрын

Except for starting out incorrectly, and ending incorrectly, it was great in between. Just pushing the brake pads in could be a problem up in the master cylinder reservoir ! You could have brake fluid forced out the cap ! At the end , you need to address how yo be sure the brske lines are bled, otherwise you will back the car out of the garage and have no brakes !

@SuperMRtimmay Жыл бұрын

thank you very much

@adampoquette5356 11 ай бұрын

Does the parking brake shoe spin in the same direction on both sides of the vehicle?

@edwardfoster5153 4 жыл бұрын

Nice video

@TRQ 4 жыл бұрын

Thanks

@4-MinuteMiles Жыл бұрын

well done.

@amstamey 3 жыл бұрын

This was f*cking quality work

@robbiematney6661 4 жыл бұрын

Great video thank you 💯

@stephaniekicks6636 3 жыл бұрын

Please can someone help me? I’ve checked and there are two different opinions on the torque spec for the rear caliper bolts. I’ve heard 55 lbs/ft but I’ve also heard about 77 Lb/ft as seen in this video. Which one is it? 2015 Jeep Wrangler unlimited sport

@gtaylor1564 6 ай бұрын

I Just by passed mine I've never used them in 12 years

@stevenwolansky8909 3 жыл бұрын

thingamadohicky.... That's golden...

@TRQ 3 жыл бұрын

+Steven Wolansky Thanks for watching our video! 1aau.to/m/Shop-TRQ

@stevenwolansky8909 3 жыл бұрын

@@TRQ Your technique for pushing back the calliper with a pry bar is a game changer. Thanks for the video...

@buddhobson5742 Жыл бұрын

Did he put the grease on the wrong side of the tins

@brendaremillard4921 4 жыл бұрын

Great video. I have a question. Is there any reason to pull out the rear axles to do a rear brake replace??? I never have done it,,, but I brought my Jeep to a mechanic,,and I saw him pulling the axles!!! My quote also went from $500 ,to $900 plus,,,for rear brakes!!! WTF!! Am I being taken, or is this a normal brake job procedure??? Thanks for any help with this issue!!

@safitz7863 4 жыл бұрын

What do you mean pulling out the rear axel? Like removing it entirely? Or are you referring to the cover on the center of it. Thats your rear differential. You'd remove that cover to clean in there before refilling with diff fluid. But I cannot see why you would have to remove the axel to change brakes. Especially if it's just pads and rotors. As a JKU owner I've learned that learning to do the maintenance yourself is the only way. Between the "technicians", and "service advisors" who know nothing beyond what their guide book tells them at the dealerships, and people who just want to rip you off by selling you a laundry list of repairs that they know they can upsell simply because it is a Jeep. It's a jungle.

@edwingonzalez6060 4 жыл бұрын

Hi, to do caliper, rotor and/or brake pads there is no need for removal of the axles, if the mechanic were changing the brake shoes and/or hardware which are the the parking brake configuration of this model it would have been necessary although not entirely because it can be made with the axles inside, with the fact that it would be harder to do.