How to replace the belts and blades on a Swisher T 60 mower

No video

How to replace the belts and blades on a Swisher T 60 mower

Рет қаралды 19,634

Ben's Machines

Күн бұрын

Music: Zig Zag, Strength of the Titans by Kevin MacLeod
#Bensmachines#DIY#Engineerathome

Пікірлер: 21

@trash2treasure2 Ай бұрын

Great video

@AndrewZebrunIII 3 ай бұрын

Thank you, the belt diagram really helped me get my lawn mowed!

@trinityacreshomestead4147 2 жыл бұрын

Excellent step by step tutorial and good video work. I’ve been looking for something explaining both belt replacements and this is the best video I’ve found. Thanks 👍👍

@tedm.674 Ай бұрын

Thank you, great video

@hurricanepb Ай бұрын

Well done. Thank you

@wesswainson254 Жыл бұрын

Thanks Ben. I have one of these mowers. I don’t remove the wire guide at the rear for the short belt. I just loosen the nuts until it swings ahead enough.

@robertengelhardt3321 2 жыл бұрын

Very nice walk through, have the older green version, blew the motor and replaced with 17.5hp version, more power. But need to replace the blades now so great video. Watched it all even though only needed the blade info, looking at the same set you put on.

@davemiller3027 3 жыл бұрын

Thanks for the information on the belts. I just picked up the same mower form my sister and it needs new belts, your video will be a huge help.

@bprieur 3 жыл бұрын

Thanks for the feedback Dave.

@breannaoliver6316 2 жыл бұрын

Ben's machine es la mejor explicacion que he visto y escuchado gracias por TU video salu2 amugo

@waynehannah2752 2 жыл бұрын

Great job well done

@bprieur 2 жыл бұрын

Thanks Wayne

@YankeeReb 2 жыл бұрын

Excellent....

@bprieur 2 жыл бұрын

Thank you!

@jerrylansbury9558 Жыл бұрын

Great video......except for the positioning of the blades ......at 31:56 Any belt driven ( anything ) will never stay timed as your suggesting in this video. Unless the blades were " chain " driven. The belt slips...and is designed to slip to prevent damage. Therefore the timing goes out the window ! Cant keep them timed.

@jamesbrady1959 Жыл бұрын

Remove tension on engine pulley? How

@bobturner8265 2 жыл бұрын

I need the digrame for a 32 imch cut azv12v8m

@brianpatterson8013 2 жыл бұрын

How tight is that drive belt when freshly installed. Mine is very tight and the blades won't disengage.

@bprieur 2 жыл бұрын

Hi Brian. The drive belt is suppose to be tight when the tensioner pulley (blades) are engaged. Reduce the engine throttle to idle first and then disengage the blades. If that doesn't work, the owner's manual says to simply shut off the engine and then disengage the blades before restarting the engine again. Hope that helps.