How to RESET/ REPROGRAM ANY HYUNDAI Computer -ECM, ECU, TCM, PCM

No video

How to RESET/ REPROGRAM ANY HYUNDAI Computer -ECM, ECU, TCM, PCM

Рет қаралды 23,046

Peter L

Күн бұрын

Пікірлер: 20

@masonhartung3339 7 ай бұрын

Dude the amount of additional sounds in this vid is crazy. Thanks for the info

@Jake-tq2vr 5 ай бұрын

😂 you ain't lying 😭 but I think he did that purposely to avoid having Hyundai or major car repair shops having them report it or taken down some how lol a lot of deep conspiracy videos are the same way hahaha

@Metbryan91 2 ай бұрын

You mean car dealerships... they want those codes cleared until ur driving 45 miles away from dealership

@CarmenGarcia-bu3so 2 ай бұрын

U talk too much but not showing anything....😢

@PatrickofShireland 5 ай бұрын

Homie are you at a circus?

@JackieStevens-v4h Ай бұрын

You talk to much saying nothing

@eddeleon4108 2 ай бұрын

This video is a joke...he sounds like he knows but doesn't show anything but turning the key to check his next service...worst video

@mikep8717 Ай бұрын

Was this an instruction video ... or a sound effects video ?? I'll be honest, when the cat showed up, I didn't stop laughing till the end of the video. And the phone notification sounds at the end were a definite plus. hahaha !! 😂

@halweilbrenner9926 4 ай бұрын

2001 Hyundai Sonata GLS with the 2.5 l V6. Lots of trans problems. Loss of trans output shaft speed sensor signal, fault code P1529 indicating trans. output shaft speed sensor signal loss. (Trans) shift control solenoids fault codes P0755 "B", P0760 "C" & P0765 loss of voltage supply to overdrive solenoid valve system. Mine has 206,000,000 miles. TPS was bad caused backfire, hesitation & rough idle. code P0720 trans output shaft speed sensor replaced. Good luck Still working on mine (trans shift solenoid replacement).

@mariagonzalez4097 3 ай бұрын

Hola, resolviste el problema?

@trexmtb4381 3 ай бұрын

I'm having an issue with an engine swap after the previous one had a damaged piston. i have the velaster turbo 2016 dual clutch version, The problem I'm encountering is that the engine isn't performing as expected. While it sounds normal and accelerates smoothly at low speeds, when I try to accelerate harder, it feels like it's not delivering power properly. The RPMs drop, almost as if the computer is limiting it. It's frustrating because when I reach 50 MPH, it doesn't accelerate as it should. Can someone tell me what could be happening?

@davidgu1699 3 ай бұрын

I have the same car 2016 hyudai tucson 1.6 turbo dual clutch, I had to put 2 oil catch cans, change transmission fluid, I had so much carbon build up and used berryman intake cleaner, runs smooth

@trexmtb4381 3 ай бұрын

@@davidgu1699 thanks I'll try that

@jonyp3511 3 ай бұрын

Its probably an ussue between the throttle body and the learn values in the computer.

@suroodameen8590 Ай бұрын

Middle finger

@98jos 29 күн бұрын

Wtf are these sounds

@user-sq4ed7iv3q Ай бұрын

You didn't show any actual content. Everyone knows how to use a scanner. You had a whole bunch of talking and turning your keys off and on which doesn't do shit. You've just wasted a lot of time for people.