How to Set an Unloader Valve (Pressure Regulator)

Рет қаралды 194,479

Күн бұрын

#pressurewashing
Also know as a pressure regulator, the unloader valve diverts water flow into bypass when the trigger gun valve is closed. Unloaders may be designed to respond to either an increase in pressure or a change in flow.
In this how to video we teach you how to properly set the unloader on your pressure washer.
General Pump YU21405 Trapped Pressure Unloader Valve
spraywell.com/general-pump-yu...
JN Equipment is now Spraywell!
🛒 Visit Our Store: spraywell.com/
🛒 Shop Pressure Washer Parts: spraywell.com/pressure-washer...
Call us: 561-964-3228
Thanks for watching!

Пікірлер: 22

@jeffthomas7383 4 жыл бұрын

Just replaced stock pump and this was exactly the info I needed to get it adjusted correctly. Thanks!

@MrSmartass89 7 жыл бұрын

Excellent video. No BS and straight to the point. Doesn't get any better than that.

@spencerknight3338 8 жыл бұрын

Best video i could find on adjusting a unloader. Good info and easy to understand. GREAT JOB.

@Spraywell 8 жыл бұрын

+Spencer Knight Thanks, glad we can help.

@dianasahlbergextremecleanp9946 8 жыл бұрын

Great video and explanation. Thanks! .

@UnderPressurePowerWashingLLc 9 жыл бұрын

Nice video, Helpful Information!

@l-skywalker-l2081 8 жыл бұрын

Great vid dude !

@owenbarnhart5771 3 жыл бұрын

Awesome info well done !

@MrROLLOXXX 7 жыл бұрын

Great video bro

@UnderPressurePowerWashingLLc 7 жыл бұрын

Educational Video. 👍

@MAGTRAIN 8 жыл бұрын

great. thanks

@FairyCatGrace 9 жыл бұрын

Nice video!

@UnderPressurePowerWashingLLc 7 жыл бұрын

David Zabala Better Then Most ! Nice work.

@DustyDawnaDigsHistory 4 жыл бұрын

Excellent .... 5⭐

@PhilGz 7 жыл бұрын

Good video, thanks for info :-)

@Spraywell 7 жыл бұрын

thanks! Glad we could help.

@mperez27 8 жыл бұрын

I have a 4000 psi @ 4 gpm and I get 4000 psi when I release handle but when spraying I only get about 3300. I have a 4.0 nozzle on the end and not sure what else I can do to raise the pressure...any advice?

@Spraywell 8 жыл бұрын

+mperez27 The highest pressure you want WHILE holding the trigger will be 3500 - 3600 psi, you just need to set your unloader a little lower by lowering the 2 locking screws as shown in this video.

@MrROLLOXXX 7 жыл бұрын

I have a economax em15-p 4000psi @4.0GPM, with the 0 degree nozzle the psi go to 3200-3300psi... I need to do your process for to obtain at least 3700-3800psi pulling the trigger?

@Spraywell 7 жыл бұрын

most likely