Thank you for explaining the inner cab corners I've been scratching my head for awhile now

Great detailed video ! Only guy on KZfaq that actually shows a close up detail of how Rockers fit . I’m definitely subscribing. This is what we want to see ! 👍

Me and buddy building one now. Replace both rocker and cab corners.

When I bought my 84 about a year and a half ago, I later found out that the floorboards were pretty rusty. Mainly because on the passenger side, the seals on the back of the kick panel had been allowed to rot, and were never replaced, so water was coming in through the HVAC port and soaking in the carpet, therefore rusting the floor pan. Both of my drains that you covered on your other video are clear and they were clear when I bought the truck.

Excellent work, good tip on pulling the door. Beautiful color choice.

So thus solves my mystery. Water “is“ meant to go into the outer rockers after all. I have been wondering about this for quite a while now. Just wanted to thank you for clearing that up for me!

Getting ready to replace cab corners and rockers on my 2014 silverado,video is really helpful.Thanks

Looks great!! Nice work!!

I subscribed immediately!

Great job

Good stuff. We are a squarebody family. We have 5 k5 blazers, 73 k30 and 86 c30 4 door dually

I’m getting inner and outer rocker panels I got the cab corner’s also to replace and have to fix the floor pan

Love the Color

I hope you paint it the metallic green - looks great.

I'm currently getting ready to do this to my 86 K10. The rocker on the passenger side is bubbling so I expect to find what you did on your C10. I was wondering, do you think it would be reasonable to fill or plug the space (hole) that lets the debri in on the firewall side? I figure it would still have ventilation from the rear. I noticed the back side rocker has an angle metal bend, blocking the crap from getting out of the rocker area. what a good design. and you have to figure, they made this basic design for decades. My corner was repaired by a shop previously with bondo only. Yes a real body shop. It failed in a few years. When I found out how they did the repair, I asked the shop why they didn't use metal. They responded that the corners couldn't be found. I can only go by what I'm told. I repaired it by cutting the rust, supporting with fiberglass and surface with bondo.. That part held up well. But I may have a support failing. I'm doing my final deep inspection in a couple days so the project can begin... Thanks for your vid, you give a lot of information.

If you notice that after your first coat of primer you need to go back and add more filler, do you need to sand the primer off? Tnx.

I’m in the same boat as you on my 85 C20. I’m gonna do a partial rocker replacement, cab corner skin, and floor patch. Is that the titanium easy flux 125? How are your windshield frames?

Dude I'd be pissed if they sent me outer rockers not full length...

I love the color of the truck in your thumbnail pic! Whats it called?

Patch those speaker holes in the door

So you cut the first rocker in half and then had to get another one and do the full rocker and then inner rocker with extra metal was for part of the floor section on top

What kind of welder did you use?

Dang I just seen a video from Paradise Mx track ! Are you from central Ga ? I’m in Eatonton

Subscribed! Will also subscribe from my truck yt channel. I’ll be working on my dads 76 stepside soon. @Mr.ChevroletTrucks