How to “Stealth” Install a Midland GMRS Radio in a Jeep Wrangler JK JKU

Рет қаралды 13,390

Жыл бұрын

Welcome to Kit & Gear!
Dell here. While overlanding, I often find myself in many back country places without cell service, so I wanted to install a two way radio in my 2011 Jeep, JK Rubicon. After looking at all the options, I decided to go with a Midland, Micro Mobile, GMRS two way radio. The model that I selected (MXT275VP4) has all of the controls incorporated into the microphone, allowing me to do a “stealth” install by hiding the radio head unit under the passenger seat, leaving only the microphone visible.
In this video, I walk you through the installation, every step of the way, sharing tips, and yes, even a few mistakes. If this sounds like something that you would like to add to your Jeep JK or JKU, give this video a look, and if you are a gear junkie, like me, then please hit the SUBSCRIBE button, and together we will review and install some of the coolest kit & gear available for our favorite overland vehicles.
ABOUT
Avid 4X4 enthusiast, gear junkie and overlander. By no means an expert, just handy enough to be dangerous.
Radio - midlandUSA.com
Mount - rammount.com
S-Pod - 4x4spod.com
E-Dock - vectoroffroad.com
#gmrs #midlandusa #midlandradio #trailcommunication #radiocommunication #midlandinstall #gmrsradio #midlandadventures #jeep #wrangler #offroad #overlanding #rubicon

Пікірлер: 27

@TrailWolf83 2 ай бұрын

I just got his radio and this video was the best I have seen! Thank you for all the details and tricks that you shared!

@lindsaykid9947 Жыл бұрын

I've installed a few radios. Not the midland ones but a few rugged radios and a couple woxoun kg1000g's. I'm impressed with the detail you took in the install. I've watched a ton of videos of people's installs and the lack of detail bothers me. Well done as you've said so yourself!

@kitgear2068 Жыл бұрын

Thank you Lindsey, I appreciate your kind words.

@ej9147 Жыл бұрын

Nice job, really like the down to earth, non-scripted and personal approach!! Keep it up!

@kitgear2068 Жыл бұрын

Thanks EJ, don’t know any other way to be…

@jr_jeep4470 Жыл бұрын

Really well done.

@kitgear2068 Жыл бұрын

Thank you, I really appreciate the nice compliment.

@MajorWeakness Жыл бұрын

Nice install

@kitgear2068 Жыл бұрын

Thank you!

@TOTALLYRELAXED 5 ай бұрын

Nice video! If it were me I’d use one of these for running wires through the firewall: Stainless Steel Wire InsertionTool - Piercing for 1/4-Inch Wiring Hole…much easier! Tool makes the hole and one merely runs the wire ‘through the tool’ into the inside of the vehicle or vice versa. Thanks for sharing! ~Jim~

@kitgear2068 5 ай бұрын

Thanks Jim, I’ll look into that. Truly learn something every day.

@Subgunman Жыл бұрын

I have been installing two way radios since the early 80’s before going into the professional business of 2-way. Todays vehicles have become nightmares to instal and work on radios and their antenna systems. You also have individuals who "do not want to drill" for mounting their antennas. Remote mount radios are the best where you hav3 a do all microphone or a control head that is small enough to mount somewhere in the cab. That fuse mounting is a BIG NO NO!! The fuse should be mounted under the hood and directly to the battery with no more than 6 inches to the battery. There should also be a fuse of the same rating going to the negative pole of the battery as well. The reason is that if there should be an open negative in the wrong area of the vehicle, you can wind up having the negative line of the radio power cable trying to carry all of the load back to the battery setting that negative lead on fire. Another little trick is to find a speedometer cable found on older cars, it makes an excellent fishing wire for pulling cables through to their destination.

@overlandvoyager2780 Жыл бұрын

great job.Take a bow.

@kitgear2068 Жыл бұрын

Thank you! I appreciate that.

@kellydiver Жыл бұрын

Thank you. I’m about to do the same thing, except I was going to put the head unit in the glove box. Now I have a decision to make because I didn’t know about that little bracket under the passenger seat.

@kitgear2068 Жыл бұрын

You bet Kelly, glad I could help!

@papatravels61 Жыл бұрын

Thank you for the sharing this i think i will do the same thing.

@kitgear2068 Жыл бұрын

Good luck, hope all goes well. If I can answer any questions, give me a shout.

@yellowdirtbiketruck Жыл бұрын

I'm getting ready to install my gmrs radio in the jku. Thanks for your video, especially the parts about the hole through the passenger side and the spod use. I also have a power unit, although not spod. Have you gotten any issues with interference on the radio since the install? Thanks again.

@kitgear2068 7 ай бұрын

Hi there yellowdirtbiketruck, Sorry for the delayed response, I’ve been having some email issues and have not been seeing comments to my channel. To answer your question; no, I have not seen any static or radio interference whatsoever. Again, sorry for the delay, I’m sure you already have your radio installed by now. 😬

@djsoundzentertainment42 Жыл бұрын

As of April 19th 2021, the fee for a license has dropped to only $35 for a ten-year license.

@kitgear2068 Жыл бұрын

Thanks for the heads up! I wish I had got in on that deal.

@1uptospeed Жыл бұрын

very detailed you earned a sub , is that a land rover in the garage?

@kitgear2068 Жыл бұрын

Thanks 1uptospeed, I appreciate the sub! And yes, that is a 92 Land Rover D90 Defender.

@schmitice 8 ай бұрын

You didn’t show how to mount the antenna.. I’m using a previously mounted cb antenna, and I don’t know if I can.. wanted 20 minutes

@kitgear2068 7 ай бұрын

Hi schmitice, So sorry for the very late response, I’ve been having some issues with receiving comments. If you haven’t already figured out the antenna mount, I would suggest you take a look at the Midland Radio site, they have several options. I used the Roll Bar/Mirror mounting bracket to mount the stealth antenna to my roof rack. Again, apologies for the late reply.